Ford 3F2Z-9A758-AA
Throttle Cable

Service and repair of the accelerator cable starts with brake-freeing its connection at the throttle body point. To free the cable from its bracket users must squeeze the tabs while also keeping in mind the cowl panel is currently removed for better visibility. The second removal step requires disconnecting the accelerator cable from its retainer clip which is mounted on the left-hand shock tower. Proceed by taking out the plastic retainer from the accelerator pedal and adjust its position for accelerator cable removal. A 16-mm deep thin wall socket should be placed over the accelerator cable end then pushed against the dash panel to free cable retainers thus making it possible to take out the accelerator cable from the engine bay. The cable installation requires you to follow the opposite steps of removal.

The accelerator cable requires service and repair by first disconnecting from the throttle body. The cowl panel is removed for clarity before using the tab compressors to take the cable off from the bracket. The accelerator cable should detach from its retainer clip which is mounted onto the left-hand shock tower. First remove the plastic retainer from the accelerator pedal before putting the pedal into position to take out the accelerator cable. A 16-mm deep thin wall socket should be slid onto the accelerator cable end to release retainers by pushing it toward the dash panel for complete accelerator cable withdrawal from the engine compartment. The installation of the new cable requires workers to follow the opposite steps of removal.

The first step to fix the throttle cable and linkage involves removing the air cleaner outlet tube unless you must detach the accelerator cable bracket. Rephrase the part removal sequence exactly as shown within the illustration and table. The accelerator cable grommet installation starts with clip removal and follows with squeezing the brackets to separate the accelerator cable from its position. The accelerator cable needs to be removed from its left-hand shock tower and air cleaner housing clips. To remove the accelerator cable from the pedal operate two steps sequentially: free the cable from the rubber plunger followed by pulling the plunger toward the rear to take the cable off. Completion of the installation process happens through the execution of steps that were previously used for removal.

Service and repair of the accelerator cable starts with brake-freeing its connection at the throttle body point. To free the cable from its bracket users must squeeze the tabs while also keeping in mind the cowl panel is currently removed for better visibility. The second removal step requires disconnecting the accelerator cable from its retainer clip which is mounted on the left-hand shock tower. Proceed by taking out the plastic retainer from the accelerator pedal and adjust its position for accelerator cable removal. A 16-mm deep thin wall socket should be placed over the accelerator cable end then pushed against the dash panel to free cable retainers thus making it possible to take out the accelerator cable from the engine bay. The cable installation requires you to follow the opposite steps of removal.