Ford 4W3Z-9A758-AA
Throttle Cable

Begin services on the accelerator cable by uninstalling the bolts securing the accelerator splash shield along with spring disconnection of the accelerator cable. You should then cut the connection between the cable and both the bracket and cable retainer. Start by separating the wiper mounting arm with the pivot shaft assembly before setting the wiring harness shield to the side. After nut removal you need to disconnect the accelerator cable from both acceleration pedal and shaft parts while observing the non-memory pedal photo because this service deals with the memory pedal model. The cable retainer must be removed before you can pull the accelerator cable through the dash panel to entirely extract it from the automobile. The reverse order of dismantling should be used during reinstallation.

Service of throttle cable and linkage necessitates first removing the bolts securing the accelerator splash shield. Before continuing separate both accelerator cable and speed control wires followed by removing the spring. The service requires removing the accelerator cable from its bracket then removing the vacuum hose. First remove the accelerator cable from its location in the cable retainer after which you can take off corresponding nuts. The service for the accelerator cable involves detaching it from the accelerator pedal and shaft at both non-memory and memory devices. Take the accelerator cable retainer off while pulling the cable from the dash panel to extract it fully from the vehicle. Anticipate the opposite actions used to remove the components during installation.