Ford XL7Z-9A758-AA
Throttle Cable

Start service and repair procedures of the accelerator pedal cable by disconnecting it from both the accelerator pedal and shaft. The service requires you to start with the left-hand side accelerator control splash shield bolts then proceed with the right-hand side splash shield bolt to finally detach the splash shield. You need to remove the accelerator cable clip first and then compress the lock tabs on the accelerator cable that exist inside the passenger area. The compressed accelerator cable will enter the engine space. Detach the fitting along with the accelerator cable from its bracket before sliding off the accelerator cable end from the throttle lever by rotating the throttle lever in the forward direction. The installation requires following all steps in reverse order to the removal.

Service and repair operations on throttle cable and linkage should start by disconnecting the accelerator cable from both pedal and shaft components. The service and repair of the throttle cable and linkage begins with bolt removal from the left-hand side accelerator control splash shield followed by the right-hand side splash shield bolt before the splash shield can be removed. The accelerator cable clip must be removed first followed by squeezing the accelerator cable lock tabs situated in the passenger compartment to push the cable into the engine bay. Start by disconnecting both the accelerator cable and fitting from the accelerator cable bracket before sliding the accelerator cable off the throttle lever forwarding the throttle lever and letting the cable end disconnect. Follow the opposite steps used in removal to reinstall.

Service and repair operations on the accelerator pedal cable require starting by removing the bolts of the accelerator control splash shield and removing the splash shield itself. The first step involves removing the accelerator cable from the throttle lever by pushing the throttle forward to slide off its end. The illustration omits representation of the speed control cable for a clear frame. Press the tabs to take out the accelerator cable from its position on the accelerator cable bracket. After disconnecting the accelerator cable from the pedal and shaft the technician will access the tabs inside the passenger space to push the cable into the engine compartment. Reverse the procedures already done to reinstall the device.

The first step to service throttle cable and linkage repair begins with the bolt removal of accelerator control splash shield followed by splash shield removal. The first part of service and cable-repair work starts with removing the throttle lever accelerator cable by rolling forward the lever and removing its end piece. The illustration depicts the speed control cable for clarity but does not show it. To free the accelerator cable from its bracket use the tabs for depressions. Proceed to detach the accelerator cable from the accelerator pedal along with its shaft. Push the accelerator cable into the engine compartment as you squeeze its lock tabs while working in the passenger compartment. You can then remove the cable from the vehicle. The installation process should reverse all removal steps.