Ford YF1Z-9A758-BA
Throttle Cable

A technician should start accelerator pedal service and repairs with cable disconnection from the pedal followed by pedal positioning for cable tension relief. The accelerator pedal retaining pin has tabs that you should depress to disconnect the cable. You need to first take out the splash shield of the accelerator cable by removing the pin-type retainers and then removing the shield itself. First disconnect the accelerator cable by setting the throttle cam at Wide Open Throttle position and removing the accelerator cable slug from the throttle cam. Unclip the accelerator cable tabs to separate the cable from its bracket while.RemoveAt last the accelerator cable grommet from the bulkhead position. To install the parts restore the removal steps in the reverse order.

Repair work on throttle cable and linkage starts by disconnecting the accelerator cable from the pedal while placing the pedal into its relaxed position to free up tension on the cable. The cable can be disconnected from the accelerator pedal by pressing down tabs on its retaining pin. The first step consists of removing the accelerator cable splash shield using the necessary steps of retaining pin removal before handling the splash shield itself. The throttle cam must first be set to Wide Open Throttle (WOT) position then the accelerator cable slug needs removal from the throttle cam before disconnection can proceed. The tabs on the accelerator cable enable detachment from the bracket and solo removal of both the grommet and cable from bulkhead location. The completion of the repair requires following the opposite order in which removal was conducted.

When servicing and repairing the accelerator cable start by disconnecting it at the pedal while placing the pedal into the position that releases cable tension. Press the tabs of the accelerator pedal retaining pin to separate the cable connection. Service to the accelerator cable starts with removing the accelerator cable splash shield after eliminating its pin-type retainers. Follow up by detaching the accelerator cable by putting the throttle cam in wide open throttle position (WOT) before taking out the accelerator cable slug from the throttle cam. The tabs on the accelerator cable need depression to disconnect the cable from the accelerator cable bracket then the grommet must be extracted from the bulkhead position. Reinstall the system with the opposite steps like removal.

Repair work on throttle cable and linkage starts by disconnecting the accelerator cable from the pedal while placing the pedal into its relaxed position to free up tension on the cable. The cable can be disconnected from the accelerator pedal by pressing down tabs on its retaining pin. The first step consists of removing the accelerator cable splash shield using the necessary steps of retaining pin removal before handling the splash shield itself. The throttle cam must first be set to Wide Open Throttle (WOT) position then the accelerator cable slug needs removal from the throttle cam before disconnection can proceed. The tabs on the accelerator cable enable detachment from the bracket and solo removal of both the grommet and cable from bulkhead location. The completion of the repair requires following the opposite order in which removal was conducted.