1995 Ford F-150 Automatic Transmission, Maintenance

Part Notes: Note: 7A191 gasket not included with 7A098 screen, 4x4

Part Notes: (QQ-94-A) ring (7B067 to 7D392) retaining 4 17/32" I.D. - 1/16" thick

Part Notes: Kit - includes sensor (F5LP 7F293-AA), necessary spacers, grommet, sleeve and I.S., BEFORE 8/27/96

Part Notes: To be used when replacement 1996/ valve body is used.

Part Notes: Plug - to block OSS/TSS hole in late E4OD service cases

Part Notes: Penetrating Lubricant - cleans, lubricates, protects, displaces moisture and frees rusty parts - (12) 9 oz. aerosol cans with 5" snorkel

Part Notes: (AB-187-KB) bolt (case to engine) - M10-1.50 x 65 (metric)

Part Notes: .219" thick - 34 teeth 3 21/32" ID x 5.00" OD 12 - plate clutch

Part Notes: (U-3-A) screw and washer (7H183 to 7A039) 1/4-20 x 0.62, 2/W/D

Part Notes: Bolt (case to engine) M10 - 1.50 x 75 (metric)

Part Notes: Premium Engine Coolant with Bittering Agent - (6) 1 gallon jugs

Part Notes: Spec. No.: Dexron II
Spec. No.: ESP M2C138-CJ
Spec. No.: MERCON

Part Notes: Retainer - push pin type - 20mm serrated pin with 60mm x 10mm wing - general use for wiring to sheet metal or blind hole retention. Use electrical tape to secure to harness. 10 per package., Service Repair Only

Part Notes: Gear kit , overdrive ring , includes 1, F6TP,7653,AA ring gear, 1, F5TP,7G375,AA retaining ring and 1, F6TP,7G375,AB retaining ring , Use with cast overdrive cylinder only

Part Notes: Pressure - .250/.260" thick at snap ring surface

Part Notes: (QQ-97) - 7" O.D. - .085" thick, retaining ring - 7B066 to cyl.
(QQ-97) 7" O.D. - .085" thick, retaining ring 7B066 to 7D044

Part Notes: 11/32" thick - 5 1/8" I.D. - 26 teeth, 4.2L,4.6L,4.9L,5.0L,5.4L,5.8L
Direct drive clutch, forward clutch rear
Rear - 11/32" thick - 5 1/8" I.D. - 26 teeth

Part Notes: Plug - speedometer hole, 4x2
Speed: All

Part Notes: .118 tooth thickness - 5.640/5.630 OD - use w/10 plate forward clutch

Part Notes: (Q-6-G)-ring (7D164 to 7060) retaining 1 13/16"

Part Notes: Hub only - used with E9TZ 7D171-AA and E6DZ 7G178-A

Part Notes: Apply side - 3.13-3.23mm Thick - 157.2-157.8mm I.D. - 26 teeth in a 30 tooth profile

Part Notes: Forward clutch front - triangle depression on face of plate
Front - 19/64" thick - 5 1/8" I.d. - 26 teeth

Part Notes: To be used when replacement 1996/ valve body is used

Part Notes: Cooling System Flush (non acid) - (12) 11 fl. oz. cans , Spec. No.: ESR M14P7-A