1998 Ford E-250 Econoline Fuel System Components, Fuel Delivery

Part Notes: Radiator cooling fan motor - use w/D8BZ 14474-C (male) - Blower motor, 2-pin rectangular connector , Wiring Circuit: 2

Part Notes: 4 cavity, female, Switch - A/C Compressor Clutch Cycling
4 cavity, female, Switch - A/C Pressure Cut Off
4 cavity, female, Switch - Barometric Pressure

Part Notes: 3 cavity, male, Alternator, with Diesel
3 cavity, male, Sensor - Brake Fluid Level

Part Notes: 3 cavity, male, Lamp - Headlamp - High/Low Beam - Non-Aero

Part Notes: 1 cavity, male, Switch - Oil Sending Unit

Part Notes: Attaches to back side of water pump under intake manifold. Slides onto the 8555. O-rings are W704593-S100., 5.4L

Part Notes: A/C low pressure tube asy, with heater/AC prep pack or prep pack deluxe, 3/4" O.D., attaches from under hood 19E558 A/C line assembly to 19752 valve located under LH front door

Part Notes: Used for fittings to connect 9R288 tank to tank fuel line, GAS/NGV Bi-Fuel

Part Notes: (AR-51-A) retainer, 5/16" tube push connect

Part Notes: (AR-51-C) retainer, 6.35mm push connect (duck bill)

Part Notes: Clip 9.0mm & clamp 18mm with tether. Attach fuel supply line to fuel rail., Gas

Part Notes: "L" shaped; 34mm High x 35mm Wide x 14mm Thick.

Part Notes: 2 cavity, male , Fuel Injector, 4.2, 4.6, 5.4
2 cavity, male , Switch , Brake Pressure

Part Notes: 2 cavity, male, Actuator - Door Lock - Sliding Door

Part Notes: 2 cavity, male, Motor - Idle Air Control
2 cavity, male, Motor - Windshield Washer Fluid Pump

Part Notes: 16 cavity, male, Test Connector - Diagnostic

Part Notes: 2 cavity, female, Coil - Ignition, 5.4, 6.8
2 cavity, female, Sensor - Camshaft Position, 4.6
2 cavity, female, Sensor - Crankshaft Position, 4.2, 4.6, 5.4, 6.8

Part Notes: 10 cavity, male, Actuator - Speed Control

Part Notes: 6 cavity, male, Switch - Heater A/C Blower (rear)

Part Notes: (AI-110-DA) push connect, female straight 5/16" connector asy., 7.9mm tube x 6.3mm hole push connect; type 3

Part Notes: Gas engines, RV prep; caps F7UZ 9S303-AB, Fuel tank aux. drain tube asy., (Stripped Chassis/Cutaway)

Part Notes: Camshaft position sensor (CKP), 2 pin , Wiring Circuit: 2
Crankshaft position sensor, 2 pin , Wiring Circuit: 2

Part Notes: Attaches to back side of water pump under intake manifold. Slides onto the 8555. O-rings are W704593-S100., 6.8L

Part Notes: Midship tank. Also serviced in 9034. Cadbar II hose material with bonded 9A064 clamp at one end. Excludes loose clamp 9A064, gas unleaded fuel

Part Notes: Use with midship fuel tank., Regular/Extended Vans/Wagons-Unleaded/Leaded/Diesel fuels

Part Notes: O-ring; Lower injector sleeve to intake manifold., Bi-Fuel; Gas/NGV

Part Notes: M6 x 1.0 x 12 hex head (screw & washer assy.) , midship tank

Part Notes: Kit to add spade type starter solenoid when vehicle had spade type

Part Notes: 3 cavity, female, Sensor - Accelerator Pedal Position
3 cavity, female, Sensor - Throttle Position

Part Notes: 4 cavity, male, Sensor - Catalyst Monitor
4 cavity, male, Sensor - O2 (HEGO/ EGO)

Part Notes: 4 cavity, male (10 gauge), Resistor - Blower Motor (Front)
4 cavity, male (10 gauge), Resistor - Blower Motor (Rear)

Part Notes: 3 cavity, female, Sensor - Delta Pressure Feedback EGR

Part Notes: 2 cavity, male (10 gauge), Motor - Heater A/C Blower (Front)

Part Notes: Dual tube asy - heater body underbody, with heater/ac prep pack,with heater/ac prep pack deluxe

Part Notes: Rubber dust cap with loop end of tether to fit over fill valve 9C112. Will retrofit for all fill valves., Gas/NGV Bi-Fuel
Rubber dust cap with loop end of tether to fit over fill valve 9C112. Will retrofit for all fill valves., NGV

Part Notes: Hose (bulk) - 3/8" tube size - 25 ft. roll

Part Notes: Clip 12.5mm & clamp 18mm with tether. Attach fuel supply line to fuel rail., Gas

Part Notes: 2 cavity, male (Tin terminals), Solenoid - Canister Vent

Part Notes: O-ring; Injector Upper. 10 per package., Bi-Fuel; Gas/NGV

Part Notes: Mounts front fuel supply/return/vapor lines (9S273/9S274/9D676). Nylon clip 3 tube holder 52mm wide w/mtg stem., Gas

Part Notes: 3 cavity, male, Lamp - Headlamp - High/Low Beam (Aero Lamp)

Part Notes: 4 cavity, male, gold terminals, Sensor - O2 (HEGO/ EGO), 5.4

Part Notes: 8 cavity, female, Motor - Heater/AC Blend Door

Part Notes: 3 cavity, male, Sensor - Cam Shaft Position, 4.2

Part Notes: 2 cavity, male, Valve - Vapor Management, 4.2, 5.4
2 cavity, male, Valve - Vapor Management, 6.8, 5.4

Part Notes: TUBING - STEEL - 3/16" O.D. - SUPPLIED IN 25 FT. ROLLS

Part Notes: O-ring; Injector sleeve to fuel rail. .380 wide x .103 thick., Bi-Fuel; Gas/NGV

Part Notes: Hose (bulk) - 5/16" tube size - 25 ft. roll

Part Notes: 3 cavity, female, Switch - Heater A/C Temperature Control

Part Notes: 1 cavity, male, Capacitor - Ignition/Radio

Part Notes: 2 cavity, female, Motor - Power Window - LH - Front
2 cavity, female, Motor - Power Window - RH - Front

Part Notes: 3 cavity, gold terminals (also reference TSB #07S57), Sensor - Camshaft Position, 7.3

Part Notes: Hose asy - A/C, with high output (auxiliary) heat/AC,jumper tube attaches from underbody a/c line to auxiliary evaporator outlet

Part Notes: O-ring; For Upper Metal injector sleeve to injector. 20.7mm OD., Bi-Fuel; Gas/LPG
O-ring; For Upper Metal injector sleeve to injector. 20.7mm OD., Bi-Fuel; Gas/NGV

Part Notes: (AE-110-EA) push connect, female straight, 3/8" x 5/16" connector asy., 9.5mm tube x 6.4mm hose; type 3

Part Notes: (Stripped Chasssis , Commercial), 124" W/B

Part Notes: F5AB-14A464-AB, mates w/12A697 air charge temp sensor, 2 cavity , Wiring Circuit: 2
F5AB-14A464-AB, mates w/9F945 solenoid cannister valve, 2 cavity , Wiring Circuit: 2

Part Notes: 2 cavity, male - gold plated terminals, Sensor - Coolant Temperature, 4.2

Part Notes: 6 cavity, 5 pin to F2UZ-19986-C blower switch

Part Notes: 3 cavity, male, Lamp - Front Turn/Side Marker
3 cavity, male, Lamp - Park/Turn/Stop

Part Notes: 2 cavity, male, Sensor - Air Charge Temperature

Part Notes: 3 cavity, male, Alternator, except Diesel

Part Notes: 3 cavity, male, Switch - Inertia (Fuel Pump)

Part Notes: Short A/C tube that attaches from the underbody tube to the auxiliary evaporator tube, with high output (auxiliary) heat/AC, 3/8" O.D.

Part Notes: #2 in illustration, Without aux. heater., BEFORE 12-10-2001

Part Notes: 4 cavity, male, Switch - Heater A/C Blower

Part Notes: 12 cavity, male, Sensor - Transmission Range

Part Notes: 5 cavity, female, Motor - Windshield Wiper

Part Notes: 2 cavity, male, Solenoid - EGR Vacuum Regulator

Part Notes: 7 cavity, female, Switch - Multi-function (steering column)

Part Notes: Junction plate, male (multiswitch), Switch - Power Window/Door Lock