1998 Ford F-250 Fuel Injection

Part Notes: Headlamp connector (spacer #E7DZ-14A468-B), U/8500 GVW , Wiring Circuit: 3

Part Notes: 16 Way Male-For Scan Tool, cover and retainer included

Part Notes: 2 cavity, male, Fuel Injector, U/8500 GVW , Wiring Circuit: 2, Color: Black

Part Notes: 2 cavity, male - includes (1) connector (1) boot, (2) terminal pigtails,(2) heat shrink butt connectors, Speed sensor, sensor located in rear axle

Part Notes: 6 cavity, male, gold terminals, Sensor - Mass Air Flow

Part Notes: 3 cavity, female, Sensor - Delta Pressure Feedback EGR, except Diesel

Part Notes: 3 cavity, male, Lamp - Front Side Marker
3 cavity, male, Lamp - Park/Turn/Stop, Flareside

Part Notes: 4 cavity, male, gold terminals, Sensor - O2 (HEGO/ EGO)

Part Notes: 8 cavity, female, Motor - Heater/AC Blend Door

Part Notes: O-ring; Injector sleeve to fuel rail. .380 wide x .103 thick., Bi-Fuel; Gas/LPG
O-ring; Injector sleeve to fuel rail. .380 wide x .103 thick., Bi-Fuel; Gas/NGV

Part Notes: O-ring; For Upper Metal injector sleeve to injector. 20.7mm OD., Bi-Fuel; Gas/LPG
O-ring; For Upper Metal injector sleeve to injector. 20.7mm OD., Bi-Fuel; Gas/NGV

Part Notes: Used for fuel filter/tank valve inlet/outlet ports, GAS/NGV Bi-Fuel

Part Notes: Multi-function switch, #13K359, 9 cavity connector, also part of #14A320, U/8500 GVW , Wiring Circuit: 9

Part Notes: Vapor Management Valve F75E-9F945-BA, U/8500 GVW , Wiring Circuit: 2

Part Notes: Multi-function switch, #13K359, 7 cavity connector, also part of #14A320, U/8500 GVW , Wiring Circuit: 7

Part Notes: 4 cavity, male, Switch - Heater A/C Temperature Control

Part Notes: 3 cavity, gold terminals (also reference TSB #07S57), Sensor - Camshaft Position, 7.3

Part Notes: (AB-208-AX)Screw/Wshr M6 x 1.0 x 42.5 Hex hd. Pilot (Attach upper/lower intake manifold).

Part Notes: 4 cavity, female, Switch - A/C Pressure Cut Off

Part Notes: One package consists of 2 pieces. Locating pins(2) located inside rubber gasket at two ports., Romeo Engine

Part Notes: F5AB-14A464-AB, mates w/9F945 solenoid cannister valve, 2 cavity, U/8500 GVW , Wiring Circuit: 2

Part Notes: 7 cavity, female, Switch - Multi-function (steering column)

Part Notes: 4 cavity, male, Switch - Heater A/C Blower

Part Notes: O-ring; Lower injector sleeve to intake manifold., Bi-Fuel; Gas/NGV

Part Notes: 4 cavity, male, Sensor - Catalyst Monitor

Part Notes: (AB-175-HY)Screw/Washer M6x1.0 x 35.5mm (Attach 9A589 Spacer to upper intake manifold & Throttle Body 9E926 to Spacer 9A589)

Part Notes: 3 cavity, female, Sensor - Accelerator Pedal Position
3 cavity, female, Sensor - Throttle Position

Part Notes: 3 cavity, male, Lamp - Headlamp - High/Low Beam

Part Notes: 3 cavity, male, Lamp - Park/Turn/Stop, Styleside

Part Notes: Kit, 12 cavity, male - for terminals contact FCS at 877-682-4276, Sensor - Transmission Range, U/8500 GVW

Part Notes: F5AB-14A464-AB, mates w/9F945 solenoid cannister valve, 2 cavity, U/8500 GVW , Wiring Circuit: 2

Part Notes: A/C cycle switch - 9 and 6 o'clock locating tab - includes 14A468 lock/spacer, O/8500 GVW , Wiring Circuit: 4
A/C cycle switch - 9 and 6 o'clock locating tab - includes 14A468 lock/spacer, U/8500 GVW , Wiring Circuit: 4

Part Notes: Pressed in block behind water pump; O-rings are W704593- S100, Under 8500 GVW

Part Notes: Kit to add spade type starter solenoid when vehicle had spade type, U/8500 GVW

Part Notes: Female 42-pin, #12A581 to #9D930, male is F1VY-14489-B, U/8500 GVW , Wiring Circuit: 42

Part Notes: Female 38-pin, #12A581 to #15525, male is F3DZ-14489-KA, U/8500 GVW , Wiring Circuit: 38

Part Notes: Also serviced in upper intake manifold 9424

Part Notes: 2 cavity, female, Sensor - Crankshaft Position , Wiring Circuit: 2