FordParts
My Garage
My Account
Cart
Blower Motor & Fan
2008 Ford Escape Cabin Air Filter, Blower Motor Resistor, Blower Motor
Currently shopping for
2008 Ford Escape
Change VehicleCategories Close X
Currently selected
A/C & Heating
Other Categories
Air & Fuel Delivery
Belts & Cooling
Body & Hardware
Brakes
Charging & Starting
Driveline & Axles
Electrical
Emission Control & Exhaust
Engine
Headlights & Lighting
Interior & Exterior Trim
Maintenance & Lubrication
Steering
Suspension
Transmission
How to use OE catalog
Diagram (1 of 1): Air Conditioner & Heater - Blower Motor & Fan (GAS)
Sort by:
Ref No.
Ref No.
Part No. & Part Description
Price & Qty.
Part No. &
Part Description
Part Description
- 1
MSRP: $155.60 Your Price: $94.571
MSRP: $33.95 Your Price: $21.381
MSRP: $33.95 Your Price: $21.381
MSRP: $70.73 Your Price: $45.32
OEM 2008 Ford Escape Parts for Blower Motor & Fan
Genuine OEM 2008 Ford Escape parts are made using the original design, the high standards, in the Ford official factories, and all of these ensure that they always fit perfectly and easily. FordPartsDeal.com is a trusted source for finding these authentic OEM Blower Motor & Fan parts at very competitive prices. Our professional team is here to help you choose the right 2008 Ford Escape Cabin Air Filter, Blower Motor Resistor, Blower Motor, and our fast delivery options ensure that your parts are always delivered quickly.
Blower Motor, Blower Motor Resistor, Cabin Air Filter Installation and Repair Tips for 2008 Ford Escape
- Q: How to service the cabin air filter on 2008 Ford Escape?A: In order to change the cabin air filter, one should begin by removing the RH cowl panel grille. Next, loosen the screws of the 2 water shields and remove the water shield. Then remove the cabin air filter. All one has to do is to reverse these steps in order to install the new filter.
- Q: How to service the blower motor resistor on 2008 Ford Escape?A: The blower motor resistor can be serviced by first lowering the glove compartment and dislodging the electrical connector to it. Next, unscrew the two screws which clamped the resistor and have to be screwed in tight to 3 Nm (27 lb-in) when fitting. Once the resistor has been removed, then replace it again, following the same procedures in reverse.
- Q: How to service the blower motor on 2008 Ford Escape?A: The blower motor is serviced by disconnecting the electrical connector. Unclip the 2 vent-tube clips and draw the tube out of the core of the heater/evaporator in order to disconnect the tube. Moving the carpet a bit. Twist the blower motor in an anti clockwise direction to release it. In order to install, undo these steps.