FordParts
My Garage
My Account
Cart
OEM 2000 Ford Excursion Voltage Regulator
Adjustable Voltage Regulator- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Voltage Regulator found
2000 Ford Excursion Voltage Regulator Part Number: F1DZ-10C359-A
Product Specifications- Other Name: Regulator And Brush; Brush & Holder; Regulator Assembly; Brushes; Regulator; Regulator And Brush Holder Assembly
- Replaces: FODZ-10316-A
- Base No.: 10C359
- Item Weight: 0.40 Pounds
- Item Dimensions: 3.9 x 2.4 x 2.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: F1DZ-10C359-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Ford Excursion Voltage Regulator
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2000 Ford Excursion Voltage Regulator available at FordPartsDeal.com. You can confidently purchase our OEM 2000 Ford Excursion Voltage Regulator as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2000 Ford Excursion Voltage Regulator Parts Q&A
- Q: How to service and repair the voltage regulator in gasoline-engine generators on 2000 Ford Excursion?A: The repair process for the voltage regulator begins with generator removal but this procedure only works for gasoline generators because 7.3L diesel engines possess a regulated generator inside their system. Start by removing the four screws that secure the voltage regulator while proceeding to separate both the generator brush and terminal holder. Separating the generator brush and terminal holder from the voltage regulator requires removing the screw cap together with the two screws fastening the brush and terminal holder. The installation process begins with placing the brush and terminal holder onto the voltage regulator then fastening with screws and putting back the screw cap which must cover Test Terminal A so the battery positive connection does not get shorted. Depress the brushes and add a wire for stabilizing them before putting in the generator brush with the terminal holder and voltage regulator set-up. Once the voltage regulator is installed, remove the wire without losing its position and complete the installation. Finally, reinstall the generator.