FordParts
My Garage
My Account
Cart
OEM 2000 Ford Mustang Fender
Wheel Fender- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Fenders found
2000 Ford Mustang Fender, Front Driver Side Part Number: XR3Z-16006-AA
Product Specifications- Other Name: Fender Assembly - Front; Fender, Front Left
- Position: Front Driver Side
- Base No.: 16005
- Item Weight: 14.60 Pounds
- Item Dimensions: 65.7 x 31.4 x 12.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: XR3Z-16006-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
- Product Specifications
- Other Name: Fender Assembly - Front; Fender, Front Right
- Position: Front Passenger Side
- Base No.: 16005
- Item Weight: 13.90 Pounds
- Item Dimensions: 66.4 x 30.7 x 12.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: XR3Z-16005-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Ford Mustang Fender
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2000 Ford Mustang Fender available at FordPartsDeal.com. You can confidently purchase our OEM 2000 Ford Mustang Fender as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2000 Ford Mustang Fender Parts Q&A
- Q: How to service the front fender on 2000 Ford Mustang?A: Commence front fender servicing by removing the antenna base which is situated on the right-hand side. The antenna service requires removing the base cap and screws then removing the base while cutting the antenna cable. You need to remove the front bumper cover and then proceed with the screw removal before handling the two pin-type retainers as well as the front rocker panel molding. The next step is to remove the splash shield screw which will enable placement of the splash shield off to one side. Continue the procedure by taking out the lower bolts of the fender as well as any installed shims on the vehicle. There are two access points to reach the inner fender bolts through the door frame and disconnect the grille opening panel from the fender bolts. You will finalize the process by removing the fender after taking off the upper bolts. You should feed the antenna cable through the fender opening on the right-hand side during installation then carry out the reverse steps to reassemble everything while examining and correcting fender alignment if needed.