FordParts
My Garage
My Account
Cart
OEM 2001 Ford Taurus Throttle Cable
Accelerator Throttle Cable- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Throttle Cables found
2001 Ford Taurus Throttle Cable Part Number: YF1Z-9A758-BA
Product Specifications- Other Name: Cable Assembly - Throttle Control
- Base No.: 9A758
- Item Weight: 2.20 Pounds
- Item Dimensions: 0.6 x 10.9 x 15.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: YF1Z-9A758-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2001 Ford Taurus Throttle Cable Part Number: YF1Z-9A758-AA
Product Specifications- Other Name: Cable Assembly - Throttle; Cable Assembly - Throttle Control
- Base No.: 9A758
- Item Weight: 0.70 Pounds
- Item Dimensions: 16.8 x 12.9 x 5.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: YF1Z-9A758-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2001 Ford Taurus Throttle Cable
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2001 Ford Taurus Throttle Cable available at FordPartsDeal.com. You can confidently purchase our OEM 2001 Ford Taurus Throttle Cable as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2001 Ford Taurus Throttle Cable Parts Q&A
- Q: How to service and repair the throttle cable and linkage on 2001 Ford Taurus?A: Repair work on throttle cable and linkage starts by disconnecting the accelerator cable from the pedal while placing the pedal into its relaxed position to free up tension on the cable. The cable can be disconnected from the accelerator pedal by pressing down tabs on its retaining pin. The first step consists of removing the accelerator cable splash shield using the necessary steps of retaining pin removal before handling the splash shield itself. The throttle cam must first be set to Wide Open Throttle (WOT) position then the accelerator cable slug needs removal from the throttle cam before disconnection can proceed. The tabs on the accelerator cable enable detachment from the bracket and solo removal of both the grommet and cable from bulkhead location. The completion of the repair requires following the opposite order in which removal was conducted.