Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2003 Lincoln LS Submodels:
Base, LSE | 6 Cyl 3.0 L GAS, 8 Cyl 3.9 L GAS
2003 Lincoln LS Seat Belt
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2003 Lincoln LS Seat Belt available at FordPartsDeal.com. You can confidently purchase our OEM 2003 Lincoln LS Seat Belt as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2003 Lincoln LS Seat Belt Parts Questions & Experts Answers
Q: What Safety Measures Should Be Taken When Servicing an Undeployed Seat Belt Pretensioner in a Scrapped on 2003 Lincoln LS?
A: The service of safety belt pretensioners in unused vehicles requires wearing safety glasses along with careful handling of safety belt retractor and pretensioner elements to stop accidental deployment because improper maintenance could trigger injuries. Transport the working safety belt retractor/pretensioner assembly with fingers and clothing clear of moving elements to prevent injuries. The procedure must happen out in open air while keeping all staff 6.1 meters (20 feet) from the deployment area and hear protection is required for the loud noise the system generates. Avoid placing the safety belt retractor/pretensioner assembly on a support surface since this could cause potential ricochet injuries. The first step entails removing the safety belt retractor/pretensioner assembly from the vehicle until you disconnect the electrical connector and strip 25 mm (1 inch) off the wire insulation. Periodic testing requires the use of two 20-gauge wires that measure exactly 20 feet in length. These wires should be linked to the pretensioner safety belt wires. Position the assembly flat on the surface at an exposed location with at least 6.1 meters space between it and any other object. You can deploy the pretensioner after attaching the wires to battery terminals housing 12-volt power. The safety belt pretensioner assemblage requires ten minutes of cooldown time before approaching followed by proper disposal as per the standard scrapping guidelines.