FordParts
My Garage
My Account
Cart
OEM 2005 Ford Freestar Fuel Level Sensor
Gas Gauge Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Fuel Level Sensor found
2005 Ford Freestar Sending Unit Part Number: 3F2Z-9H307-A
$168.13 MSRP: $228.80You Save: $60.67 (27%)Product Specifications- Other Name: Sender and Pump Assembly; Fuel Pump Module with Strainer Set.
- Replaces: PFS-21, 3F2Z-9H307-AB
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 3F2Z-9H307-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2005 Ford Freestar Fuel Level Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2005 Ford Freestar Fuel Level Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2005 Ford Freestar Fuel Level Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2005 Ford Freestar Fuel Level Sensor Parts Q&A
- Q: How to service and repair the fuel level sensor on 2005 Ford Freestar?A: Service and repair operations on the fuel level sensor should start by setting the vehicle to neutral gear position and placing it on a hoist. First relieve pressure in the fuel system to stop accidental spraying before disconnecting the battery cable. Secure the fuel pump module by documenting how to reinstall the sending unit wire. First detach the fuel pump module wire harness while unwrapping the sending unit wire then take off the heat shrink tube and disconnect the electrical connector. The fuel gauge sending unit extraction requires removal of the screw and subsequent lifting and removal of the unit. Install the fuel gauge sending unit wire into the center of the fuel pump module while both wires should be placed behind the metal sending unit plate during installation. Position the fuel gauge sending unit onto the pump module while keeping the grounding eyelet on the front side and apply torque to the screw through the grounding eyelet. You should use a heat gun to heat up the heat shrink tube before attaching it to the wire harness and electrical connector. When the fuel pump module is back in place, the sending unit wire needs to wrap around the harness to prevent float arm disruption.