My Garage
Cart

OEM 2005 Lincoln Town Car Dimmer Switch

Light Dimmer Switch
  • Select Vehicle by Model
  • Select Vehicle by VIN
Select Vehicle by Model
Make
Model
Year
or
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Dimmer Switch found

  • 2005 Lincoln Town Car Dimmer Switch Diagram - 3W1Z-11691-AA
    View related parts
    Product Specifications
    • Other Name: Resistor Assembly; Headlight Dimmer Switch; Instrument Light Rheostat
    • Manufacturer Note: Thumbwheel design
    • Base No.: 11691
    • Item Weight: 0.30 Pounds
    • Condition: New
    • Fitment Type: Direct Replacement
    • SKU: 3W1Z-11691-AA
    • Warranty: This genuine part is guaranteed by Ford's factory warranty.
    More Info
    Fits the following 2005 Lincoln Town Car Submodels:
    • Cartier, Cartier L, Designer Series, Executive, Executive L, Executive Protection Series, Protection Series, Signature, Signature L, Signature Limited, Ultimate, Ultimate L | 8 Cyl 4.6 L FLEX, 8 Cyl 4.6 L GAS

2005 Lincoln Town Car Dimmer Switch

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2005 Lincoln Town Car Dimmer Switch available at FordPartsDeal.com. You can confidently purchase our OEM 2005 Lincoln Town Car Dimmer Switch as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2005 Lincoln Town Car Dimmer Switch Parts Q&A

  • Q: How to Address Issues with the Dimmer Switch on a 2005 Lincoln Town Car?
    A: The first step for servicing and repairing the headlamp dimmer switch requires a battery disconnection. The first step to remove the ignition switch lock cylinder is to use an ignition key to turn it to "RUN" position before using a punch to push the release tab while pulling the cylinder out. Service and repair of the headlamp dimmer switch begins with disconnecting the battery before taking off the tilt wheel handle and shank. Next, use two hands to push sides of the upper shroud and unfasten the three screws from the lower shroud. Three electrical connectors need removal from the multifunction switch before removing its two mounting screws. The installation ends by performing the reverse steps of removal.