Other Name: Muffler And Pipe Assembly; Exhaust Muffler; Exhaust Pipe; Muffler And Pipe Assembly - Rear; Muffler
Manufacturer Note: Extension Pipes (5A212) And Mufflers (5230) Are To Be Replaced As A Set
Position: Rear
Base No.: 5230A
Condition: New
Fitment Type: Direct Replacement
SKU: 6L3Z-5230-AA
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2006 Ford F-150 Submodels:
FX4, Harley-Davidson Edition, King Ranch, Lariat, XL, XLT | 8 Cyl 5.4 L FLEX, 8 Cyl 5.4 L GAS
2006 Ford F-150 Muffler
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Ford F-150 Muffler available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Ford F-150 Muffler as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Ford F-150 Muffler Parts Q&A
Q: How to service and repair the muffler and tailpipe on 2006 Ford F-150?
A: Becoming ready for repairing the muffler and tailpipe requires first positioning the vehicle in neutral in a hoist. Oily substances must never be applied to isolators due to their harmful effect on rubber materials. Always follow the procedure for extension pipe-to-muffler assembly coupling loosening because a new extension pipe and coupling assembly needs replacement. First loosen each coupling of the exhaust intermediate pipe with the muffler and tailpipe, then remove the bolt and the front muffler exhaust bracket and isolator from the frame followed by disconnecting the rear muffler exhaust bracket and isolator before removing the tailpipe exhaust bracket and isolator. Start the muffler and tailpipe assembly removal process by taking out the corresponding components. Start installation from the front of the vehicle and wait to tighten fasteners until you finish component assembly and alignment. Scrape away all rust that appears on the exhaust clamp surface through use of an abrasive pad. After putting the muffler and tailpipe assembly in position begin installing the front muffler exhaust hanger bracket and its isolator to the frame until it reaches 20 Nm (15 ft. lbs.). Second in the sequence comes the installation of the rear muffler exhaust hanger bracket and isolator on the frame tight to 20 Nm (15 ft. lbs.) Next comes the tailpipe exhaust hanger bracket and isolator which also requires tight to 20 Nm (15 ft. lbs.). The exhaust system requires final alignment before tightening all exhaust system clamps.