OEM 2006 Ford Fusion Clutch Master Cylinder

2006 Ford Fusion Clutch Master Cylinder Parts Q&A

• Q: How to service and repair the clutch master cylinder on 2006 Ford Fusion?

  A: Start clutch master cylinder repairs by removing the instrument panel underneath while executing a clutch master cylinder nut removal procedure followed by installation at 21 Nm (15 ft. lbs.). A proper suction device should be used to remove brake fluid from the clutch reservoir until it reaches a point below the hose location. The service begins with battery and battery tray removal after which the electrical connectors and powertrain control module (PCM) bolts need to be unfastened. When working on the PCM bracket removal, users should disconnect the clutch master cylinder to clutch slave cylinder hydraulic line and tighten the connection to 17 Nm (13 ft. lbs.) before reinstallation. Chassis technicians need to disconnect the clutch master cylinder hose before removing its master cylinder nut and tighten the nut to 21 Nm (15 ft. lbs.) when installing. The last step involves uninstalling the clutch master cylinder assembly and performing its reverse installation method afterward you should bleed the clutch hydraulic system. Brake fluid poses hazards that require immediate treatment with water following any spillage because it causes personal injury and damages painted and plastic surfaces.