OEM 2006 Ford Mustang Windshield

2006 Ford Mustang Windshield Parts Q&A

• Q: How to reseal a windshield on 2006 Ford Mustang?

  A: You should start windshield resealing by removing right-hand and left-hand A-pillar trim panels followed by the overhead console. First separate the sun visors from the vehicle by unscrewing two parts and removing two clips from both left-hand and right-hand sides. Support the front part of the headliner while it rests on an appropriate backing material. Convertibles need the removal of their header trim panel as well. You must eliminate the cowl vent screen before implementing a non-alcohol based glass cleaning solution on the windshield glass interior and exterior surfaces. The urethane adhesive applicator tip requires cutting to specific dimensions before applying the adhesive through a high-ratio electric or battery-operated caulk gun in a consistent bead formation without gaps. It is necessary to spread urethane adhesive across the existing urethane on windshield top and sides from inside the vehicle and to apply it on the bottom from exterior of the vehicle. Inspection of the windshield glass seal must be performed when the urethane has dried to check for any leaks or tears where extra urethane adhesive may be required for addition. The windscreen cowl vent screen goes back into position and convertibles require putting back both the header trim panel as well as A-pillar trim panels. To replace the front part of the coupe headliner follows by installing sun visors with clip and screw fasteners before reattaching the overhead console and A-pillar trim elements. Finish the installation by taking required adjustments of the wiper blade and pivot arms.