FordParts
My Garage
My Account
Cart
OEM 2007 Ford Focus Canister Purge Valve
Vapor Canister Purge Valve EVAP- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Canister Purge Valves found
2007 Ford Focus Vent Control Solenoid Part Number: 6F9Z-9F945-AA
$81.05 MSRP: $117.98You Save: $36.93 (32%)Ships in 1-3 Business DaysProduct Specifications- Other Name: Solenoid Assembly; Vapor Canister Purge Solenoid; Vapor Canister Vent Solenoid; Filter Solenoid; Solenoid; Vent
- Replaces: 5U5Z-9F945-CA
- Base No.: 9F945
- Item Weight: 1.00 Pounds
- Item Dimensions: 5.8 x 3.9 x 2.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6F9Z-9F945-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Ford Focus Solenoid Valve Part Number: 7U5Z-9C915-D
$69.62 MSRP: $110.55You Save: $40.93 (38%)Ships in 1-3 Business DaysProduct Specifications- Other Name: Valve Assembly; Vapor Canister Vent Solenoid Bracket; Purge Solenoid; Emission Check Valve; Canister Purge Valve; Purge Valve; Purge Control Valve; Vapor Canister Vent Solenoid
- Manufacturer Note: Valve Only
- Base No.: 9C915
- Item Weight: 1.00 Pounds
- Item Dimensions: 6.2 x 4.6 x 3.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7U5Z-9C915-D
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Ford Focus Canister Purge Valve
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Ford Focus Canister Purge Valve available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Ford Focus Canister Purge Valve as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Ford Focus Canister Purge Valve Parts Q&A
- Q: How to service and repair the evaporative emission canister purge valve on 2007 Ford Focus?A: Before working on the evaporative emission canister purge valve, it is essential to disconnect the battery ground cable for fuel vapor safety reasons. Remove the two pin-type retainers combined with the heat shield which attaches to the EVAP purge valve. Service of the EVAP canister purge valve starts with unplugging its electrical connector and removing connectors between the two vapor tubes and the valve using quick connect couplings. Release the mounting bracket of the EVAP canister purge valve by pushing the locking tab. The installation process requires the reverse order of removal procedures. Perform a leak test of the evaporative emission system and execute an evaporative emission repair verification drive cycle after finishing up installation.