OEM 2007 Ford Focus Throttle Body

2007 Ford Focus Throttle Body Parts Q&A

• Q: How to service the throttle body on 2007 Ford Focus?

  A: Service processes on the throttle body begin with disconnecting the ground cable of the battery. Start by detaching the crankcase breather tube from the air cleaner outlet pipe followed by loosening its clamps until you successfully remove the pipe. Tighten the clamps to 4 Nm (35 lb-in) when reinstalling everything. Unfasten the accelerator control snow shield by extracting the upper snow shield screw with its pin-type retainer and tighten it to 10 Nm (89 lb-in) during installation. Disconnect the throttle body end of the accelerator cable and speed control cable if present as well as disconnect the throttle position sensor electrical connector. The throttle body should be removed by loosening its four securing bolts to ensure proper inspection of the gasket before performing new gasket installation. To install the throttle body you should follow the specified sequence when tightening its bolts to 10 Nm (89 lb-in) before you return to the reverse order of the removal procedure.