OEM 2007 Ford Mustang Brake Master Cylinder

2007 Ford Mustang Brake Master Cylinder Parts Q&A

• Q: How to service and repair the brake master cylinder on 2007 Ford Mustang?

  A: The first step to repair the brake master cylinder requires approved DOT 3 motor vehicle brake fluid since alternative fluids will permanently harm the system making brakes nonfunctional with risks for personal injury. The warning section from the product label and the MSDS document require detailed examination. Additional details lie within these documents. For medical emergency support regarding Ford/Motorcraft products you should call 1-800-959-3673. Painted along with plastic surfaces need protective measures against brake fluid spraying which should be cleaned up right away using water. Begin the operation by placing the A/C suction accumulator to the side. Then use a wrench to remove the two securing bolts before setting the accumulator to the side. To proceed with the procedure first disconnect the brake fluid sensor electrical connector followed by removing the clutch hose clamp when dealing with vehicles with manual transmissions. Additionally disconnect the clutch hose from the brake fluid reservoir. Before removing the two brake tubes from the brake master cylinder users must cap the brake lines and plug brake master cylinder ports while securing attachments to 17 Nm (13 ft. lbs.) torque upon reconnection. Discard and remove the two brake master cylinder nuts before extraction then reinstall them with a torque of 25 Nm (18 ft. lbs.). Complete the service by performing a bleeding procedure after you have reversed the removal steps.