My Garage
Cart

OEM 2007 Ford Taurus Ignition Switch

Starter Ignition Switch
  • Select Vehicle by Model
  • Select Vehicle by VIN
Select Vehicle by Model
Make
Model
Year
or
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Ignition Switch found

  • 2007 Ford Taurus Ignition Switch Diagram - F4DZ-11572-B
    View related parts

    2007 Ford Taurus Ignition Switch Part Number: F4DZ-11572-B

    $46.77 MSRP: $75.45
    You Save: $28.68 (39%)
    ADD TO CART
    Product Specifications
    • Other Name: Switch Assembly - Ignition
    • Base No.: 11572
    • Item Weight: 0.60 Pounds
    • Item Dimensions: 4.2 x 4.2 x 3.4 inches
    • Condition: New
    • Fitment Type: Direct Replacement
    • SKU: F4DZ-11572-B
    • Warranty: This genuine part is guaranteed by Ford's factory warranty.
    More Info
    Fits the following 2007 Ford Taurus Submodels:
    • G, GL, LX, SE, SE Comfort, SEL, SES, SHO, SVG | 6 Cyl 3.0 L FLEX, 6 Cyl 3.0 L GAS, 6 Cyl 3.2 L GAS, 6 Cyl 3.8 L GAS, 8 Cyl 3.4 L GAS

2007 Ford Taurus Ignition Switch

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Ford Taurus Ignition Switch available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Ford Taurus Ignition Switch as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2007 Ford Taurus Ignition Switch Parts Q&A

  • Q: How to service and repair the ignition switch on 2007 Ford Taurus?
    A: Service and repair operations on the ignition switch must begin by disabling the supplemental restraint system (SRS). The procedure requires removal of two lower screws from the instrument panel steering cover followed by removing the cover itself and installing both components tightly at 9 Nm (80 inch lbs). The service requires two bolt removals that secure the instrument panel steering column opening cover reinforcement before tightening them to 15 Nm (11 ft. lbs) for reinstallation. Disconnect the ignition switch electrical connector followed by removing two ignition switch screws while taking appropriate measures to tighten everything to 7 Nm (62 inch lbs) during installation. Conclude the procedure by reinstalling the supplemental restraint system (SRS) and perform all required power sequence.