Other Name: Center High Mount Stop Light Bulb; Rear Back Up Light Assembly; Tail Light Bulbs; Turn Signal Bulbs; Car Bulbs; Backup Lamp Bulb; Signal, Marker, Stop, High Mount Bulbs; Exterior Bulbs.
Position: Rear Inner
Replaces: E8GY-13466-B, F4BZ-13466-D
Base No.: 13466
Item Weight: 1.20 Pounds
Item Dimensions: 0.4 x 0.4 x 1.1 inches
Condition: New
Fitment Type: Direct Replacement
SKU: E6DZ-13466-B
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2007 Lincoln Mark LT Submodels:
Other Name: Center High Mount Stop Light Bulb, Engine Compartment, Trunk, Dome, Map, Interior, and Tail Light Bulbs.; Dome Lamp Assembly; Exterior Bulbs; Map Lamp Bulb
Base No.: 13466
Item Weight: 0.30 Pounds
Item Dimensions: 0.4 x 0.4 x 1.0 inches
Condition: New
Fitment Type: Direct Replacement
SKU: D8BZ-13466-A
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2007 Lincoln Mark LT Submodels:
Other Name: Bulb; Turn Signal & Parking Light Bulb, Front; Rear; Side Marker; Headlight; Back Up; Brake; Tail Light Bulbs; Backup Lamp Bulb; Signal Lamp Bulb; Parking Lamp Bulb; Stop Lamp Bulb; Exterior Bulbs
Position: Front
Replaces: F5AZ-13466-A
Base No.: 13466
Item Weight: 0.40 Pounds
Item Dimensions: 0.4 x 0.4 x 1.0 inches
Condition: New
Fitment Type: Direct Replacement
SKU: YR3Z-13466-AD
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2007 Lincoln Mark LT Submodels:
Base | 8 Cyl 5.4 L GAS
2007 Lincoln Mark LT Fog Light Bulb
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Lincoln Mark LT Fog Light Bulb available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Lincoln Mark LT Fog Light Bulb as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Lincoln Mark LT Fog Light Bulb Parts Q&A
Q: How to Service the Fog Light Bulb on 2007 Lincoln Mark LT?
A: Service of the fog lamp bulb starts by putting both the headlamp switch and ignition switch into OFF position. You should position the vehicle on a hoist while it remains in neutral gear. Disconnect the electrical connector then remove the fog lamp bulb by handling it only through its base for protection against glass envelope damage since the bulb runs under pressured gas. The duration of bulb removal should be short because prolonged time without the bulb generates adverse effects on performance and creates contamination risks in the headlamp. It is unsafe to operate the fog lamp with its bulb missing from the system. For installation of the new bulb just perform the reverse steps of removal.