Other Name: Center High Mount Stop Light Bulb; Rear Back Up Light Assembly; Tail Light Bulbs; Turn Signal Bulbs; Car Bulbs; Backup Lamp Bulb; Signal, Marker, Stop, High Mount Bulbs; Exterior Bulbs.
Position: Rear Inner
Replaces: E8GY-13466-B, F4BZ-13466-D
Base No.: 13466
Item Weight: 1.20 Pounds
Item Dimensions: 0.4 x 0.4 x 1.1 inches
Condition: New
Fitment Type: Direct Replacement
SKU: E6DZ-13466-B
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2008 Lincoln Mark LT Submodels:
Other Name: Center High Mount Stop Light Bulb, Engine Compartment, Trunk, Dome, Map, Interior, and Tail Light Bulbs.; Dome Lamp Assembly; Exterior Bulbs; Map Lamp Bulb
Base No.: 13466
Item Weight: 0.30 Pounds
Item Dimensions: 0.4 x 0.4 x 1.0 inches
Condition: New
Fitment Type: Direct Replacement
SKU: D8BZ-13466-A
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2008 Lincoln Mark LT Submodels:
Other Name: Bulb; Turn Signal & Parking Light Bulb, Front; Rear; Side Marker; Headlight; Back Up; Brake; Tail Light Bulbs; Backup Lamp Bulb; Signal Lamp Bulb; Parking Lamp Bulb; Stop Lamp Bulb; Exterior Bulbs
Position: Front
Replaces: F5AZ-13466-A
Base No.: 13466
Item Weight: 0.40 Pounds
Item Dimensions: 0.4 x 0.4 x 1.0 inches
Condition: New
Fitment Type: Direct Replacement
SKU: YR3Z-13466-AD
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2008 Lincoln Mark LT Submodels:
Base | 8 Cyl 5.4 L GAS
2008 Lincoln Mark LT Fog Light Bulb
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Lincoln Mark LT Fog Light Bulb available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Lincoln Mark LT Fog Light Bulb as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Lincoln Mark LT Fog Light Bulb Parts Q&A
Q: How to Service the Fog Light Bulb on 2008 Lincoln Mark LT?
A: The service process for the fog lamp bulb should begin by setting both the headlamp switch and ignition switch to the off position. The neutral gear position allows the vehicle to sit on a hoist. You should disconnect the electrical connector and remove the fog lamp bulb with basic base handling since the bulb operates under compressed gas pressure and it can shatter if contact is made with the glass envelope. A prolonged removal of the bulb and any contact with the envelope should be avoided because these actions may impact headlamp bulb operation while permitting contaminants to access the headlamp area. The fog lamp system always requires the bulb in place to function properly. The installation of the new bulb requires performing the removal steps in reverse order.