OEM 2007 Lincoln Town Car Transmission Pan

2007 Lincoln Town Car Transmission Pan Parts Questions & Experts Answers

• Q: How to Service and Repair the Transmission Pan, Gasket, and Filter on 2007 Lincoln Town Car?

  A: Before maintenance of the fluid pan and gasket with filter always remove any additional cleaning agents or transmission fluid additives because they can produce internal transmission component failure. Start by placing the vehicle into NEUTRAL mode on the hoist while draining all transmission fluid through loosening pan bolts. After draining the fluid you should remove the bolting system then proceed through the transmission fluid pan and gasket. After pulling down the transmission fluid filter and seal remove them while you thoroughly inspect the fluid pan along with its gasket and magnet. Before fitting a new filter check that all remaining seal from the main control bore is cleared with a small screwdriver while remaining cautious about damaging the bore surface. For contamination-related failure servicing use a new filter and new seal yet excessive contamination does not require a new filter. Place the new fluid filter and seal before putting the pan magnet in the fluid pan. Then install the gasket remembering to select a clean and undamaged version. Fasten the transmission fluid pan with its gasket while tightening each bolt to 14 Nm (10 ft. lbs). The transmission requires a fluid addition of 4.7L (5 qt) of new automatic transmission fluid at the correct fill mark.