FordParts
My Garage
My Account
Cart
OEM 2007 Mercury Monterey Fuel Level Sensor
Gas Gauge Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Fuel Level Sensor found
2007 Mercury Monterey Sending Unit Part Number: 3F2Z-9H307-A
$168.13 MSRP: $228.80You Save: $60.67 (27%)Product Specifications- Other Name: Sender and Pump Assembly; Fuel Pump Module with Strainer Set.
- Replaces: PFS-21, 3F2Z-9H307-AB
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 3F2Z-9H307-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Mercury Monterey Fuel Level Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Mercury Monterey Fuel Level Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Mercury Monterey Fuel Level Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Mercury Monterey Fuel Level Sensor Parts Q&A
- Q: What Safety Precautions Should Be Observed When Servicing the Fuel Level Sensor on 2007 Mercury Monterey?A: Safety measures are essential for fuel level sensor servicing because highly flammable vapors are present, so avoid lighted tobacco and open flames as well as personal electronic devices near fuel-related components. It is vital to relieve fuel system pressure before disconnection of any parts to stop uncontrolled fuel spray. Start the process by taking out the fuel pump module from the system. Make a record of the sensor wire path which will be required later and then release the wire from its harness connection to the fuel pump module. After the heat shrink tube covers the electrical connector, release it to detach the connector from the circuit. Remove the screw in order to extract the fuel level sensor from its place. Install the wires of the fuel level sensor through the fuel pump module center while positioning them behind the metal sensor plate during assembly. Install the sensor to the fuel pump module while positioning the eyelet at the front, then insert and fasten the screw through the eyelet. The installation requires using a heat gun to heat the tube instead of an open flame while sliding the heat shrink tube onto the wire harness and connecting the electrical connector. Fortify the sensor wire by looping it over the fuel pump module wire harness in order to minimize float arm disturbance and put everything back into position.