FordParts
My Garage
My Account
Cart
OEM 2008 Ford E-250 Mass Air Flow Sensor
MAF Sensor Meter- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Mass Air Flow Sensor found
2008 Ford E-250 Mass Air Flow Sensor Part Number: 3L3Z-12B579-BA
$156.67 MSRP: $257.78You Save: $101.11 (40%)Product Specifications- Other Name: Sensor Assembly; Air Charge Temperature Sensor; Intake Air Temperature Sensor; MAF Sensor; Sensor
- Manufacturer Note: 4.6L, Police
- Base No.: 12B579
- Item Weight: 1.20 Pounds
- Item Dimensions: 6.3 x 2.5 x 2.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 3L3Z-12B579-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Ford E-250 Mass Air Flow Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Ford E-250 Mass Air Flow Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Ford E-250 Mass Air Flow Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Ford E-250 Mass Air Flow Sensor Parts Q&A
- Q: How to Service the Mass Air Flow Sensor on 2008 Ford E-250?A: You should start by removing the air cleaner before performing service on the Mass Air Flow (MAF) sensor. Handling the MAF sensor elements should be done carefully to prevent a unit breakdown. Start by opening the air cleaner then unfasten the clamp on the air box while removing the inlet side from the outlet side of the air cleaner. Following the removal of the latches users can extract the MAF assembly from the system. Detach the electrical connector only after verifying that the red clip extends beyond the connector. Disconnect the MAF sensor electrical connector before you take off the screws holding the MAF sensor in place. Install the new sensor and fasten its screws to 2 Nm (18 lb-in). Check that the engine air cleaner housing grommet at the extension harness has complete seating to stop unmetered air from entering the engine. You should use the alignment notch to put the inlet and outlet sides of the engine air cleaner in the correct position before finishing the installation with the reverse steps of removal.