OEM 2008 Ford Edge Air Bag Sensor

2008 Ford Edge Air Bag Sensor Parts Questions & Experts Answers

• Q: How to service the Air Bag Sensor located in the B-pillar on 2008 Ford Edge?

  A: Service of the B-pillar side impact sensor begins by determining if the vehicle sustained a crash; examine the RCM and mounting regions for deformation before repairing them if necessary. A new RCM combined with sensors always need installation post-impact regardless of air bag functionality. New RCM components and sensors need installation in all circumstances to stop fatal outcomes from happening. When removing the RCM fuse next to the ignition switch in ON position the air bag warning indicator will illuminate but this normal action implies no failure exists. A vehicle cannot be handed back to customers unless the supplemental restraint system (SRS) operates without faults. Repeating the diagnostic procedure should come after reinstalling the original part when new part replacement fails to resolve the issue. Commence operations by positioning the front seat forward before depowering the SRS system. You can remove the front and rear door scuff plates by pulling upward until retaining clips release so you can detach the retainers from the B-pillar trim panel that runs over the lower area. Disconnect the side impact sensor electrical connector since improper torque on RCM and impact sensor fasteners can lead to restraint system malfunction. Thoroughly clean both the B-pillar and side impact sensor mating areas from debris before marking down the side impact sensor position of its locating tabs for future installation. Separate the bolt before removing the side impact sensor, before your installation of the new sensor require a torque of 11 Nm (8 lb-ft). Reinstall the SRS while performing the opposite procedures in their correct order.