FordParts
My Garage
My Account
Cart
OEM 2008 Ford Edge Vapor Canister
Fuel Vapor Canister- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Vapor Canister found
2008 Ford Edge Vapor Canister Part Number: 7T4Z-9D653-B
$261.08 MSRP: $443.64You Save: $182.56 (42%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Cannister - Fuel Vapour Storage; Vapor Canister Purge Solenoid; Cannister - Fuel Vapour Store
- Base No.: 9D653
- Item Weight: 10.60 Pounds
- Item Dimensions: 7.1 x 11.9 x 30.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7T4Z-9D653-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Ford Edge Vapor Canister
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Ford Edge Vapor Canister available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Ford Edge Vapor Canister as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Ford Edge Vapor Canister Parts Q&A
- Q: How to Service and Repair the Vapor Canister on 2008 Ford Edge?A: The procedure for servicing and repairing the evaporative emission control canister starts by placing the vehicle in the neutral gear on a hoist where the hoist arm supports the frame lifting point. To start servicing the evaporative emission control canister disconnect the battery ground cable then remove the three bolts, pin-type retainer and the evap shield before reinstallation tighten the bolts to 9 Nm (80 lb-in). The service begins with disconnecting the evap canister vent solenoid electrical connector and performing quick disconnect operations for the fuel vapor tube-to-evap canister assembly and the fuel vapor tube assembly-to-evap canister assembly before disconnecting the fuel vapor tube from the dust separator. Replace the three bolts of the evap canister but maintain a torque of 9 Nm (80 lb-in) during the installation process. The pin-type retainer should be released after disconnecting the evap canister. Before securing the new canister with bolts and pin-type retainer begin by inserting the alignment tab into the body of the component. Perform a evaporative emission system leak test after the installation while doing the evap repair verification drive cycle.