FordParts
My Garage
My Account
Cart
OEM 2008 Ford Taurus X ABS Control Module
Anti Lock Brake Control Module- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 ABS Control Modules found
2008 Ford Taurus X Control Module Part Number: 8G1Z-2C219-F
Product Specifications- Other Name: Control; ABS Control Module; Module
- Replaces: 8G1Z-2C219-C
- Base No.: 2C219
- Item Weight: 1.70 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8G1Z-2C219-F
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Ford Taurus X Modulator Valve Part Number: 8G1Z-2C346-F
$1805.63 MSRP: $2469.23You Save: $663.60 (27%)Product Specifications- Other Name: Module - ABS Control; ABS Hydraulic Assembly; ABS Control Module; ABS Control Unit; Control Assembly
- Manufacturer Note: ECU & HCU
- Replaces: 8G1Z-2C346-C
- Base No.: 2C306
- Item Weight: 6.20 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8G1Z-2C346-F
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Ford Taurus X ABS Control Module
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Ford Taurus X ABS Control Module available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Ford Taurus X ABS Control Module as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Ford Taurus X ABS Control Module Parts Q&A
- Q: How to Handle and Install the ABS Control Module for the Electronic Brake System on 2008 Ford Taurus X?A: The Anti-Lock Brake System (ABS) Module inside the Electronic Brake Control Module needs special attention during handling since electrical charges can easily cause harm when the module becomes exposed. You must use vehicle-specific as-built data to configure a new ABS module before performing the calibration according to the scan tool guidance. First eliminate the hydraulic control unit (HCU) while disposing of its four screws. During new ABS module installation verify the new screws require tightening to 3 Nm (27 lb-in). The ABS module removal process ends with completing the reverse of installation steps.