OEM 2008 Ford Taurus X Air Bag Sensor

2008 Ford Taurus X Air Bag Sensor Parts Questions & Experts Answers

• Q: How to Service the Air Bag Sensor in the Second Row, C-Pillar on 2008 Ford Taurus X?

  A: The side impact sensor servicing procedure starts with checking if the vehicle was involved in an accident. If the vehicle was impacted, check the restraints control module (RCM) along with the impact sensor mounting areas for any damage. Restore both parts to their original state if needed. New RCM and sensors must be installed no matter the air bag deployment status to prevent serious injury or death. New RCM components along with sensors need installation in any case to avoid dangerous injuries or fatalities. Using memory saver devices leads to increased chances of accidental air bag deployment therefore must be avoided for safety reasons. The RCM fuse removal during the ON ignition status will activate the air bag warning indicator yet this condition remains normal without SRS fault detection. The SRS must function without defects to allow vehicle release. New component installation is needed for repairs yet maintenance checks should start from reinstallation of the original part followed by another diagnostic check. Start by bringing down power to the SRS system and remove the trim panels to disconnect the electrical connector of the side impact sensor. Proper operation of the RCM and impact sensor requires you to fasten their components at the designated torque value. Make note of the side impact sensor position along with its locating tab since they will be needed during reinstallation. Additionally clean all mating surfaces. Installing the new sensor requires bolt removal alongside the side impact sensor before adding the sensor and tightening it to 12 Nm (9 lb-ft). The counter procedure should be followed to turn the power back on to the SRS.