Other Name: Center High Mount Stop Light Bulb; Rear Back Up Light Assembly; Tail Light Bulbs; Turn Signal Bulbs; Car Bulbs; Backup Lamp Bulb; Signal, Marker, Stop, High Mount Bulbs; Exterior Bulbs.
Position: Rear Inner
Replaces: E8GY-13466-B, F4BZ-13466-D
Base No.: 13466
Item Weight: 1.20 Pounds
Item Dimensions: 0.4 x 0.4 x 1.1 inches
Condition: New
Fitment Type: Direct Replacement
SKU: E6DZ-13466-B
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2008 Lincoln Mark LT Submodels:
Other Name: Center High Mount Stop Light Bulb, Engine Compartment, Trunk, Dome, Map, Interior, and Tail Light Bulbs.; Dome Lamp Assembly; Exterior Bulbs; Map Lamp Bulb
Base No.: 13466
Item Weight: 0.30 Pounds
Item Dimensions: 0.4 x 0.4 x 1.0 inches
Condition: New
Fitment Type: Direct Replacement
SKU: D8BZ-13466-A
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2008 Lincoln Mark LT Submodels:
Other Name: Bulb; Turn Signal & Parking Light Bulb, Front; Rear; Side Marker; Headlight; Back Up; Brake; Tail Light Bulbs; Backup Lamp Bulb; Signal Lamp Bulb; Parking Lamp Bulb; Stop Lamp Bulb; Exterior Bulbs
Position: Front
Replaces: F5AZ-13466-A
Base No.: 13466
Item Weight: 0.40 Pounds
Item Dimensions: 0.4 x 0.4 x 1.0 inches
Condition: New
Fitment Type: Direct Replacement
SKU: YR3Z-13466-AD
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2008 Lincoln Mark LT Submodels:
Base | 8 Cyl 5.4 L GAS
2008 Lincoln Mark LT Headlight Bulb
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Lincoln Mark LT Headlight Bulb available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Lincoln Mark LT Headlight Bulb as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Lincoln Mark LT Headlight Bulb Parts Q&A
Q: How to service the headlight bulb on 2008 Lincoln Mark LT?
A: The procedures to service a headlamp bulb start with turning both the headlamp switch and ignition switch to OFF position. Proceed by taking out the headlamp assembly. The process requires counterclockwise rotation of the headlamp bulb by 1/8 turn until it detaches from the assembly while handling it at its base to prevent personal injury because high pressure gas contained inside the bulb may break when the glass envelope gets damaged. The bulb should not be taken out until right before putting on a new one because prolonged bulb exposure risks performance degradation while dirt can settle on both the lens and reflector surface. The procedure for bulb installation follows the opposite order of removal steps to successfully install the new bulb. Always avoid operating the headlamp if the bulb is currently absent.