FordParts
My Garage
My Account
Cart
OEM 2008 Lincoln MKX Heater Core
HVAC Heater Core- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Heater Core found
2008 Lincoln MKX Heater Core Part Number: 7T4Z-18476-A
$96.14 MSRP: $181.82You Save: $85.68 (48%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Core Assembly - Heater; HVAC Heater Core
- Manufacturer Note: Includes Seal
- Base No.: 18476
- Item Weight: 3.20 Pounds
- Item Dimensions: 8.3 x 14.4 x 17.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7T4Z-18476-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Lincoln MKX Heater Core
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Lincoln MKX Heater Core available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Lincoln MKX Heater Core as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Lincoln MKX Heater Core Parts Q&A
- Q: How to service and repair the heater core on 2008 Lincoln MKX?A: The first service step when maintaining the heater core requires you to perform a pressure leak test unless leaks were detected. Start by taking out the heater core together with evaporator core housing followed by floor duct screws removal and floor duct desolation. The first step is to extract the heater core tube dash panel seal after which you should unfasten the heater tube bracket screw and remove the heater tube bracket. The technician should first remove five fresh air inlet duct screws followed by the fresh air inlet duct while disconnecting the wire harness from the plenum chamber. Carefully remove the seven screws from the lower facing plenum chamber while maintaining the heater core and evaporator core housing oriented upright toward the plenum chamber. The plenum chamber extraction requires first neatly located removal of both the upper plenum chamber screw and the two plenum chamber clips. Dislodgement of the evaporator core must be avoided throughout this step. The heater core should be handled away from its inlet or outlet tubes in order to avoid damage. Removing the heater core requires holding it by its heater tube connection core-side before extracting half of it out from the plenum chamber. Subsequently grasp the top of the core to complete the removal. A proper inspection of the drain seal and its reinstallation become necessary after you detect that the evaporator core shifted during removal. Reverse the steps of removal to install the heater core.