FordParts
My Garage
My Account
Cart
OEM 2008 Lincoln Town Car Ignition Lock Cylinder
Ignition Key Lock Cylinder- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Ignition Lock Cylinders found
Product Specifications- Other Name: Lockset - Complete Vehicle; Ignition Cylinder; Lock Cylinder
- Base No.: 11582
- Item Weight: 0.70 Pounds
- Item Dimensions: 3.1 x 2.6 x 3.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5W1Z-11582-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Product Specifications- Other Name: Cylinder Assembly - Lock; Door Lock Cylinder; Lock Cylinder Assy
- Position: Driver Side
- Replaces: 3W1Z-5421991-AA
- Base No.: 21991
- Item Weight: 0.70 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6W1Z-5421991-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Lincoln Town Car Ignition Lock Cylinder
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Lincoln Town Car Ignition Lock Cylinder available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Lincoln Town Car Ignition Lock Cylinder as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Lincoln Town Car Ignition Lock Cylinder Parts Q&A
- Q: How to Service a Non-Functional Ignition Lock Cylinder on 2008 Lincoln Town Car?A: The battery disconnect procedure becomes the first step to service an ignition switch lock cylinder that is non-functioning. You should first detach the tilt wheel handle along with the shank before removing the three screws holding the lower steering column shroud in place. Move on to remove the steering wheel and set the shift selector boot to the side. First unlock the ignition switch lock cylinder by removing its cap before letting loose both tabs to remove the passive anti-theft system (PATS) transceiver from the steering column. First disconnect the electrical connector then pull out the PATS transceiver from the circuit. You should drill the lock cylinder retaining pin with a 1/8-inch diameter drill bit before breaking loose the ignition lock cylinder by drilling through its central key slot using a 3/8-inch diameter drill. Take out both the ignition lock cylinder together with all drill parings as you inspect the steering column for potential damage before cleaning the area completely. The installation process should begin by reversing all the previous steps for removal.