How to properly maintain and replace the Fuel Pump Driver Module on 2008 Mercury Mountaineer?

Installation of/ removal of Fuel Pump Driver Module (FPDM): To service the FPDM, the rear quarter trim panel, RH, should be removed, the electrical connector should be disconnected, and the module should be unbolted. Installation of the new module requires tightening of bolts to 10 Nm (89 lb-in) and to reverse the steps which were made during removal to complete the installation.

OEM 2008 Mercury Mountaineer Fuel Pump Driver Module

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Fuel Pump Driver Module found

View related parts
2008 Mercury Mountaineer Module Part Number: 6L2Z-9D372-A
$117.94 MSRP: $228.89
You Save: $110.95 (49%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Module - Engine Fuel; Fuel Pump Housing; Fuel Pump Driver Module
- Replaced by: 5L8Z-9D370-A
- Base No.: 9D372
- Item Weight: 2.20 Pounds
- Item Dimensions: 7.7 x 7.1 x 4.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6L2Z-9D372-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2008 Mercury Mountaineer Submodels:
- Base, Premier | 6 Cyl 4.0 L GAS, 8 Cyl 4.6 L GAS

2008 Mercury Mountaineer Fuel Pump Driver Module

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Mercury Mountaineer Fuel Pump Driver Module available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Mercury Mountaineer Fuel Pump Driver Module as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2008 Mercury Mountaineer Fuel Pump Driver Module Parts Q&A

Q: How to properly maintain and replace the Fuel Pump Driver Module on 2008 Mercury Mountaineer?
A: Installation of/ removal of Fuel Pump Driver Module (FPDM): To service the FPDM, the rear quarter trim panel, RH, should be removed, the electrical connector should be disconnected, and the module should be unbolted. Installation of the new module requires tightening of bolts to 10 Nm (89 lb-in) and to reverse the steps which were made during removal to complete the installation.