FordParts
My Garage
My Account
Cart
OEM 2009 Ford Crown Victoria Brake Booster
Brake Power Booster- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Brake Booster found
2009 Ford Crown Victoria Brake Booster Part Number: 7W7Z-2005-A
$307.41 MSRP: $425.27You Save: $117.86 (28%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Booster Assembly - Brake; Power Brake Booster; Power Booster
- Replaces: 6W7Z-2005-AA
- Base No.: 2005
- Item Weight: 10.50 Pounds
- Item Dimensions: 17.3 x 12.8 x 12.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7W7Z-2005-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Crown Victoria Brake Booster
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Crown Victoria Brake Booster available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Crown Victoria Brake Booster as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford Crown Victoria Brake Booster Parts Q&A
- Q: How to service and repair the vacuum brake booster on 2009 Ford Crown Victoria?A: The vacuum brake booster service starts with disconnecting both the brake fluid level sensor electrical connector and brake booster check valve. When reinstalling the two master cylinder brake nuts apply 23 Nm (17 lb-ft) torque force to each. The first step requires disconnecting the wiring harness bracket before setting it away while pulling the brake master cylinder forward toward removal. Uninstall the instrument panel steering column cover from the dashboard. You need to start with dissembling the stoplamp switch and speed control deactivator switch with the brake pedal sitting at rest because extending the switch plungers during removal can harm the bracket. Special attention must be paid to the stoplamp switch removal prior to removing the speed control deactivator switch from the vehicle if it is equipped. Attach the release the brake booster push rod retaining pin cover followed by the retaining pin, washer, bushing, and switch before pulling the booster push rod from the pedal pin. The power brake booster can be separated from the dashboard by removing four brake pedal bracket nuts which should be fastened to 28 Nm (21 lb-ft) torque specifications when reinstalling. You should not interact with the brake pedal or manipulate the stoplamp switch and speed control deactivator switch while installation due to the need for the booster push rod to stay attached to the brake pedal at its rest position. After installing the brake booster input rod with correct orientation follow the reversing steps of removal to complete the installation.