FordParts
My Garage
My Account
Cart
OEM 2009 Ford Crown Victoria Crankshaft Position Sensor
Engine Crankshaft Position Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Crankshaft Position Sensor found
2009 Ford Crown Victoria Crankshaft Position Sensor Part Number: 1W7Z-6C315-AB
$41.11 MSRP: $65.27You Save: $24.16 (38%)Ships in 1 Business DayProduct Specifications- Other Name: Sensor - Crankshaft Position; Engine Crankshaft Position Sensor; Crankshaft Sensor; Position Sensor; Sensor - Crankshaft Position - Cps
- Manufacturer Note: Sensor asy. (Crankshaft position) #1W7E 6C315-AA
- Replaces: 1W7Z-6C315-AA
- Base No.: 6C315
- Item Weight: 0.30 Pounds
- Item Dimensions: 8.1 x 6.2 x 4.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 1W7Z-6C315-AB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Crown Victoria Crankshaft Position Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Crown Victoria Crankshaft Position Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Crown Victoria Crankshaft Position Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford Crown Victoria Crankshaft Position Sensor Parts Q&A
- Q: How to Safely Service the Crankshaft Position Sensor on 2009 Ford Crown Victoria?A: A safe method to service the crankshaft position (CKP) sensor begins with disabling the fire suppression system due to serious injury risks. Place the vehicle in neutral position for hoisting on a stand. When rotating the tensioner you should remove the drive belt that is hiding the A/C compressor pulley. The A/C compressor field coil receives connector removal at the same time as the CKP sensor electrical connector. Detach the two wiring harness clips by removing the nut and tighten them to 9 Nm (80 lb-in) when reassembling. Users should not separate the A/C compressor stud bolts yet they need to loosen these bolts by just one inch to let the compressor move down before re-tightening them to 25 Nm (18 lb-ft) during reinstallation. The CKP sensor requires a bolt removal and installation will require torque at 10 Nm (89 lb-in). Repower the vehicle with its fire suppression system after finishing installation while strictly following safety warnings which protect against severe personal injury.