FordParts
My Garage
My Account
Cart
OEM 2008 Ford Crown Victoria Crankshaft Position Sensor
Engine Crankshaft Position Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Crankshaft Position Sensor found
2008 Ford Crown Victoria Crankshaft Position Sensor Part Number: 1W7Z-6C315-AB
$41.11 MSRP: $65.27You Save: $24.16 (38%)Ships in 1 Business DayProduct Specifications- Other Name: Sensor - Crankshaft Position; Engine Crankshaft Position Sensor; Crankshaft Sensor; Position Sensor; Sensor - Crankshaft Position - Cps
- Manufacturer Note: Sensor asy. (Crankshaft position) #1W7E 6C315-AA
- Replaces: 1W7Z-6C315-AA
- Base No.: 6C315
- Item Weight: 0.30 Pounds
- Item Dimensions: 8.1 x 6.2 x 4.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 1W7Z-6C315-AB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Ford Crown Victoria Crankshaft Position Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Ford Crown Victoria Crankshaft Position Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Ford Crown Victoria Crankshaft Position Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Ford Crown Victoria Crankshaft Position Sensor Parts Q&A
- Q: How to Service the Crankshaft Position Sensor on 2008 Ford Crown Victoria?A: Start the service of the crankshaft position (CKP) sensor by depowering the fire suppression system for safety reasons. It is necessary to place the vehicle on a hoist with neutral gear engaged. Lift the drive belt off the A/C compressor pulley after you rotate the tensioner. Then disconnect the accessories for the field coil of the A/C compressor and the CKP sensor. Sever the two wiring harness clips from their nut and after reassembly replace all components with 9 Nm (80 lb-in) torque. A/C compressor stud bolts do not need removal because users should loosen them to allow the compressor to slide downward by one inch before tightening them to 25 Nm (18 lb-ft) torque. The first step is to loosen and then remove the bolt connecting the CKP sensor but you must tighten this bolt to 10 Nm (89 lb-in) before moving forward. After this remove the sensor itself. Repower the vehicle according to safety instructions if it has a fire suppression system post-installation in order to prevent severe personal harm.