FordParts
My Garage
My Account
Cart
OEM 2009 Ford Edge Heater Core
HVAC Heater Core- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Heater Core found
2009 Ford Edge Heater Core Part Number: 7T4Z-18476-A
$96.14 MSRP: $181.82You Save: $85.68 (48%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Core Assembly - Heater; HVAC Heater Core
- Manufacturer Note: Includes Seal
- Base No.: 18476
- Item Weight: 3.20 Pounds
- Item Dimensions: 8.3 x 14.4 x 17.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7T4Z-18476-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Edge Heater Core
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Edge Heater Core available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Edge Heater Core as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford Edge Heater Core Parts Q&A
- Q: How to service and repair the heater core on 2009 Ford Edge?A: The first step when servicing or repairing the heater core requires testing for a leak through a pressure test. Start by uninstalling the heater core system together with the evaporator core housing module. The first step involves removing the floor duct through unfastening its six mounting screws. First remove the dash panel seal by disconnecting its heater core tube and then proceed to remove the bracket screw and bracket. The removal process requires taking out the fresh air inlet duct by removing its 5 screws. You need to remove the 7 screws holding the lower facing plenum chamber while disconnecting the wire harnesses from the plenum chamber. Remove the upper facing plenum chamber screw alongside both plenum chamber clips when the heater core and evaporator core housing stands upright before extracting the plenum chamber by maintaining the evaporator core position. You should hold the heater core from its core-side tubing connections since this protects the tube junctions from damage. Detach the heater core partially from the plenum chamber before acquiring it at the top for complete extraction. Inspection of the evaporator core shift demands a core replacement and the correct installation of the drain seal. The installation process ends following an inversion of the removal sequence.