FordParts
My Garage
My Account
Cart
OEM 2009 Ford F-250 Super Duty Automatic Transmission Filter
AT Filter- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Automatic Transmission Filter found
2009 Ford F-250 Super Duty Filter Part Number: 8C3Z-7A098-D
$61.11 MSRP: $100.55You Save: $39.44 (40%)Ships in 1 Business DayProduct Specifications- Other Name: Screen Assembly; Transmission Oil Filter; Transmission Filter
- Manufacturer Note: FILTER SEAL ASM TRANS OIL
- Replaces: 8C3Z-7A098-C
- Base No.: 7A098
- Item Weight: 3.20 Pounds
- Item Dimensions: 15.9 x 15.3 x 1.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8C3Z-7A098-D
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford F-250 Super Duty Automatic Transmission Filter
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford F-250 Super Duty Automatic Transmission Filter available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford F-250 Super Duty Automatic Transmission Filter as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford F-250 Super Duty Automatic Transmission Filter Parts Q&A
- Q: How to Service and Repair the In-Line Automatic Transmission Filter for the TorqShift Transmission on 2009 Ford F-250 Super Duty?A: The repair of the TorqShift transmission in-line fluid filter requires using only the manufacturer-specified filter to prevent damages to the transmission. An overhauled transmission that used an in-line filter needs a new filter during its installation process. A new in-line transmission fluid filter kit should be installed to the vehicle that did not come with the filter. The repair guidelines specify that filters and kits should never get installed for any non-internal repairs. Operation of a new or Ford-authorized remanufactured transmission requires the installation of a designated in-line transmission fluid filter. The first step involves placing the vehicle on a hoist with neutral gear selection. Place the tubing ferrule hose assembly connector into the cleaned and de-burred end of the cut tubing before finger-tightening the ferrule nut and then tightening it another one and one-half turns. The in-line transmission fluid filter requires installation with the arrow marking that points toward the transmission and away from the transmission fluid cooler. The filter must not accept any rubber hose or steel tubing with more than 60-degree bending direction. Install an appropriate hose length to put the in-line transmission fluid filter in position and then secure the clamps. The-semibold section on the transmission fluid pan should be cleaned before placing the sticker. Coast the transmission while performing the function check then verify correct operation before validating the in-line transmission fluid filter for leaks. Finish by adding fluid to reach the specified level.