OEM 2009 Ford Flex Air Bag Sensor

2009 Ford Flex Air Bag Sensor Parts Q&A

• Q: How to Service the Air Bag Sensor in the C-Pillar After a Side Impact Crash on 2009 Ford Flex?

  A: An inspection of the side impact sensor position in the C-pillar requires examination of both the restraints control module (RCM) and impact sensor mount points for signs of damage which should take place after any crash involvement. The installation of new RCM sensors and sensors is required for every vehicle even if air bags did not deploy during a crash. Also normalize the mounting areas to return to their original position when finding any damage. Failure to follow this procedure may result in fatal injuries in future crashes. The air bag warning indicator will activate when the proper RCM fuse is disconnected and the ignition is switched ON and the Supplemental Restraint System (SRS) needs to be completely functional and damage-free for vehicle delivery. Start the procedure by disabling the SRS power then detach both the quarter trim panel and side impact sensor electrical connector. The side impact sensor bolt must be removed before extracting the sensor and the new sensor needs installation at 12 Nm (106 lb-in) torque. Crasworthiness depends on proper torque fastening of both impact sensor and RCM connectors because improper restraint operation endangers vehicle occupants. A thorough inspection of both mating surfaces between the C-pillar and side impact sensor must be conducted before proceeding with reversing the removal steps to allow for proper installation. Finally, repower the SRS.