My Garage
Cart

OEM 2009 Ford Flex Fuel Pump Driver Module

  • Select Vehicle by Model
  • Select Vehicle by VIN
Select Vehicle by Model
Make
Model
Year
or
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Fuel Pump Driver Module found

  • 2009 Ford Flex Fuel Pump Driver Module - GA8Z-9D370-A
    2009 Ford Flex Fuel Pump Driver Module Diagram - GA8Z-9D370-A
    View related parts

    2009 Ford Flex Fuel Pump Relay Part Number: GA8Z-9D370-A

    $66.46 MSRP: $128.98
    You Save: $62.52 (49%)
    Ships in 1 Business Day
    ADD TO CART
    Product Specifications
    • Other Name: Control Unit; Fuel Pump Driver Module; Multi Purpose Relay; Fuel Pump Controller; Relay; Module
    • Replaces: 8U5Z-9345-C, 8U5Z-9345-D, AA8Z-9345-A, AA8Z-9D370-D, AA8Z-9D370-B, AA8Z-9D370-A
    • Item Weight: 0.60 Pounds
    • Condition: New
    • Fitment Type: Direct Replacement
    • SKU: GA8Z-9D370-A
    • Warranty: This genuine part is guaranteed by Ford's factory warranty.
    More Info
    Fits the following 2009 Ford Flex Submodels:
    • Limited, SE, SEL, Titanium | 6 Cyl 3.5 L GAS

2009 Ford Flex Fuel Pump Driver Module

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Flex Fuel Pump Driver Module available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Flex Fuel Pump Driver Module as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2009 Ford Flex Fuel Pump Driver Module Parts Q&A

  • Q: How to Service and Repair the Fuel Pump Driver Module on 2009 Ford Flex?
    A: Service and repair of the Fuel Pump Driver Module requires starting by taking out the RH C-pillar trim panel. Proceed with disconnecting the electrical connector from the Fuel Pump (FP) module and then free the wire harness retainer clip. The technique during removal must avoid excessive fastener tightening because it risks harming the module while the method for installation calls for 5 Nm (44 lb-in) torque on the 2 FP driver module nuts. The process ends through performing reverse steps of the removal procedures.