FordParts
My Garage
My Account
Cart
OEM 2009 Ford Mustang Fuel Pump Driver Module
- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Fuel Pump Driver Modules found
2009 Ford Mustang Control Module Part Number: 5L8Z-9D370-A
$98.10 MSRP: $190.40You Save: $92.30 (49%)Product Specifications- Other Name: Control Unit; Fuel Pump Driver Module; Fuel Pump Housing; Fuel Pump Controller; Module
- Replaces: 4L2Z-9D372-AA, 4L2Z-9D372-BA, 6L2Z-9D372-A, 7R3Z-9D372-BA, 4L2Z-9D372-A, 5L3Z-9D370-A
- Base No.: 9D370
- Item Weight: 1.00 Pounds
- Item Dimensions: 8.5 x 4.6 x 2.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5L8Z-9D370-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Mustang Fuel Pump Controller, Driver Side Part Number: 6R3Z-9D372-BA
$98.10 MSRP: $190.40You Save: $92.30 (49%)Product Specifications- Other Name: Module - Engine Fuel; Fuel Pump Driver Module; Module
- Position: Driver Side
- Replaced by: 5L8Z-9D370-A
- Base No.: 9D372
- Item Weight: 1.10 Pounds
- Item Dimensions: 3.1 x 3.5 x 6.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6R3Z-9D372-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Mustang Fuel Pump Driver Module
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Mustang Fuel Pump Driver Module available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Mustang Fuel Pump Driver Module as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford Mustang Fuel Pump Driver Module Parts Q&A
- Q: How to removing and installing the Fuel Pump Driver Module (FPDM) on 2009 Ford Mustang?A: Installation and removal of the Fuel Pump Driver Module (FPDM) at the spare tire stowage compartment requires disconnecting the electrical connector and removing two securing bolts. After removal, the FPDM can be installed by reversing the removal steps while securing the bolts to a torque specification of 10 Nm (89 lb-in).