FordParts
My Garage
My Account
Cart
OEM 2009 Ford Ranger Exhaust Pipe
Exhaust Tail Pipe- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Exhaust Pipe found
2009 Ford Ranger Extension Part Number: 4L5Z-5K238-AA
$92.17 MSRP: $115.00You Save: $22.83 (20%)Product Specifications- Other Name: Extension - Exhaust Pipe; Exhaust Tail Pipe; Exhaust Tip
- Replaces: 4L5Z-5202-A, 7L5Z-5202-A
- Base No.: 5202
- Item Weight: 2.30 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4L5Z-5K238-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Ranger Exhaust Pipe
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Ranger Exhaust Pipe available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Ranger Exhaust Pipe as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford Ranger Exhaust Pipe Parts Q&A
- Q: How to Service and Repair the Exhaust Pipe Downpipe for the 2.3L Engine on 2009 Ford Ranger?A: Place the 2.3L vehicle for exhaust downpipe servicing by placing it on a hoist in neutral position. Disconnect the electrical connectors of both Heated Oxygen Sensor (HO2S) and Catalyst Monitor Sensor (CMS). Separate the exhaust downpipe from the muffler and tailpipe assembly through removal of two bolts and two flagnuts with a gasket that must be discarded. The exhaust manifold next to downpipe requires the removal of two retaining nuts before their disposal. You need to uninstall the transmission mount together with the isolator-to-transmission bolt to detach the exhaust downpipe. Installation should be carried out without oil or grease-based lubricants on isolators since rubber deterioration will occur. Clean every contact point on the exhaust downpipe before setting its proper position into the vehicle. Place the transmission mount with an isolator-to-transmission bolt installed and tighten it at 90 Nm (66 lb-ft). Fasten together two new exhaust downpipe-to-exhaust manifold nuts while tightening them to 40 Nm (30 lb-ft). After placing the exhaust downpipe-to-muffler and tailpipe assembly gasket follow the installation of two exhaust downpipe-to-muffler and tailpipe assembly bolts with two new flagnuts and tighten to 40 Nm (30 lb-ft). The final step requires reconnecting HO2S and CMS electrical connectors after which technicians should validate the exhaust system isolators maintain zero load position; additional exhaust system alignment must occur if zero load is not achieved.