FordParts
My Garage
My Account
Cart
OEM 2009 Lincoln MKS Vapor Canister
Fuel Vapor Canister- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Vapor Canister found
2009 Lincoln MKS Vapor Canister Part Number: AG1Z-9D653-D
$152.49 MSRP: $250.91You Save: $98.42 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Cannister - Fuel Vapour Storage; Vapor Canister Bracket; Vapor Canister Purge Solenoid
- Replaces: 8G1Z-9D653-K, AG1Z-9D653-B, CX-2343, CX-2363, CX-2512, CX-2492, AG1Z-9D653-C
- Item Weight: 7.10 Pounds
- Item Dimensions: 7.1 x 16.7 x 23.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: AG1Z-9D653-D
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Lincoln MKS Vapor Canister
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Lincoln MKS Vapor Canister available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Lincoln MKS Vapor Canister as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Lincoln MKS Vapor Canister Parts Q&A
- Q: How to Service and Repair the Vapor Canister on 2009 Lincoln MKS?A: Before performing service or repair on the evaporative emission control canister start by positioning the vehicle on hoist with neutral gear select and disconnecting the battery ground cable. Disconnection of the ground cable from the battery ensures electrical safety during work. You must clean both the EVAP canister vent solenoid electrical connector along with its vicinity until all foreign substances are removed before removing the vent solenoid electrical connector. The procedure starts with removing the fuel vapor tube-to-EVAP canister quick connect coupling before disconnecting the fuel vapor tube assembly-to-EVAP canister quick connect coupling and finishing with the fresh air hose-to-dust separator. You must uninstall the four EVAP canister nuts but remember to torque all of them to 9 Nm (80 lb-in) during reinstallation. You must remove the EVAP canister after you remove the rivet. The new canister installation requires following the reversal of removal steps along with performance of the evaporative emission system leak test to verify proper system operation.