FordParts
My Garage
My Account
Cart
OEM 2009 Lincoln MKX Tie Rod
Steering Tie Rod- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Tie Rod found
2009 Lincoln MKX Inner Tie Rod Part Number: 7T4Z-3280-A
$61.51 MSRP: $103.27You Save: $41.76 (41%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Rod; Steering Tie Rod End, Inner; Inner Tie Rod End; Tie Rod End
- Position: Inner
- Base No.: 3280
- Item Weight: 1.70 Pounds
- Item Dimensions: 19.2 x 6.1 x 0.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: 7T4Z-3280-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Lincoln MKX Tie Rod
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Lincoln MKX Tie Rod available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Lincoln MKX Tie Rod as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Lincoln MKX Tie Rod Parts Q&A
- Q: How to service and repair the inner tie rod on 2009 Lincoln MKX?A: The service and repair of inner tie rod starts with steering gear removal with supportive markings on pinion shaft and steering gear housing for future reinstallation needs. Position the steering gear into a soft-jaw vise but protect it from harm before loosening the tie-rod jam nut according to specifications and finally tightening it to 90 Nm (66 lb-ft). After tearing out the outer tie-rod end and tie-rod jam nut replace the new components by tightening them to 48 Nm (35 lb-ft). The correct replacement of right-hand inner tie rods requires complete removal of both bellows boots together with four bellows clamps and two steering gear bellows boots. You will require an appropriate wrench to maintain the piston shaft steady when eliminating the inner tie rod then apply 103 Nm (76 lb-ft) torque during installation while continuing to hold the piston shaft. When reinstalling perform the removal procedures in reverse order while also checking reusable parts for cleanliness and inspecting them before installing new components if needed.