FordParts
My Garage
My Account
Cart
OEM 2009 Lincoln Navigator Throttle Position Sensor
TPS Switch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Throttle Position Sensor found
2009 Lincoln Navigator Throttle Position Sensor Part Number: 6L2Z-9B989-D
$88.26 MSRP: $145.22You Save: $56.96 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Potentiometer - Engine Throttle; Throttle Pos Sensor; Throttle Sensor; Potentiometer
- Replaces: 3L5Z-9B989-AA, 6L2Z-9B989-B, 6L2Z-9B989-A, DY-1049
- Base No.: 9B989
- Item Weight: 0.40 Pounds
- Item Dimensions: 8.3 x 7.7 x 7.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6L2Z-9B989-D
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Lincoln Navigator Throttle Position Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Lincoln Navigator Throttle Position Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Lincoln Navigator Throttle Position Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Lincoln Navigator Throttle Position Sensor Parts Q&A
- Q: How to Service and Repair the Throttle Position Sensor on 2009 Lincoln Navigator?A: A technician must start the Throttle Position (TP) sensor service by taking off the Throttle Body (TB). The TP sensor as well as plastic parts should not receive direct heat exposure because the Electronic Throttle Body (ETB) temperature exceeding 120 °C (248°F) can result in heat damage. An 1,100-watt heat gun should be used to apply heat to the ETB top for about three minutes while keeping it 25.4 mm (1 in) away from the surface to warm the top TP sensor bolt ear to 55 °C (130°F). A digital temperature laser and infrared thermometer should be used to track temperature measurements during this process. Begin by swiftly unthreading the bolt which is the most distant from the heater source followed by removing the second bolt and discarding them both. To initiate the process remove the TP sensor while discarding it. When installing the new TP sensor maintain proper alignment between the radial locator tab of the sensor and the radial locator hole present in the ETB. You should apply hand tools to install 2 new bolts before tightening them to 3 Nm (27 lb-in). After this, put the TB back into place.