How to service the Occupant Detection Sensor on the power seat track on Ford Edge?

The servicing process for the occupant detection sensor on the power seat track begins by handling the front passenger seat assembly and track with care to prevent damage occurrence. It is normal for the air bag warning indicator to show illumination when both the restraints control module (RCM) fuse is extracted and the ignition switch is ON. Operation of the SRS with all faults repaired should precede vehicle handover to the customer. Remove the power seat track by first notating the positions of its two rails. To perform this task start by detaching the nut and safety belt buckle from the inboard ODS weight sensor bolt followed by removing the front retainer and outboard seat track riser cover shield. The two retainers together with the Occupant Detection Sensor weight sensor bolt protection bracket must be extracted. To fix the defective ODS weight sensor bolt on one side you must remove its nut from the seat track front cross brace while discarding both ODS weight sensor bolt nuts from that side. Cut the front seat track motor cable away from the damaged seat track rail before taking off its side plate with ODS weight sensor bolts installed. The plate should be clamped to a bench or table without excessive tightening because damage will occur. The retaining clip on the faulty ODS weight sensor bolt must be discarded before opening the clamp to extract the bolt with its spring washer. Start by setting the ODS weight sensor bolt together with spring washer inside the side plate before using the clamp to compress it. Remove the clamp from the side plate when the retaining clip sits completely in the groove under the ODS weight sensor O-ring seal. Reinstall the front seat track motor cable and ODS weight sensor bolts according to their necessary positions on the seat track rail and secure them using two new ODS weight sensor bolt nuts tightened to 33 Nm (24 lb-ft). Install the front cross brace seat track nut while providing a torque of 20 Nm (15 lb-ft). Install the ODS weight sensor bolt protection bracket together with the two retainers followed by the front retainer and outboard seat track riser cover shield. The last step involves installing the safety belt buckle and nut while tightening them to 40 Nm (30 lb-ft). The power seat track and passenger seat should be reinstalled afterward. Repower the SRS but delay the proof out procedure and execute the correct procedure based on original or new ODS system component installation which requires a Zero Seat Weight Test or System Reset procedure.

OEM Ford Edge Occupant Detection Sensor

OPDS Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

13 Occupant Detection Sensors found

View related parts
Ford Edge Position Sensor, Front Part Number: 7T4Z-14B416-B
$26.36 MSRP: $37.38
You Save: $11.02 (30%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Sensor - Seat Position; Seat Track Position Sensor, Front, Left; Air Bag Sensor; Sensor
- Position: Front
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2014 Ford Edge | Limited, SE, SEL, SEL Plus, Sport | 4 Cyl 2.0 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.7 L GAS
View related parts
Ford Edge Module, Passenger Side Part Number: CT4Z-14B422-A
$153.52 MSRP: $208.91
You Save: $55.39 (27%)
ADD TO CART
Product Specifications
- Other Name: Monitor - Airbag Diagnostic Module
- Manufacturer Note: Module
- Position: Passenger Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2012 Ford Edge | Limited, SE, SEL, Sport | 4 Cyl 2.0 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.7 L GAS
View related parts
Ford Edge Module, Passenger Side Part Number: BT4Z-14B422-A
$104.82 MSRP: $145.01
You Save: $40.19 (28%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Monitor - Airbag Diagnostic Module
- Manufacturer Note: Module
- Position: Passenger Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2011 Ford Edge | Limited, SE, SEL, Sport | 6 Cyl 3.5 L GAS, 6 Cyl 3.7 L GAS
View related parts
Ford Edge Position Sensor, Passenger Side Part Number: JJ5Z-14B416-B
$20.56 MSRP: $29.17
You Save: $8.61 (30%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Seat Position; Seat Track Position Sensor, Front Right, Right
- Position: Passenger Side
- Replaced by: JJ5Z-14B416-E
- Replaces: DG9Z-14B416-B, DG9Z-14B416-F, JJ5Z-14B416-D
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2015-2024 Ford Edge | SE, SEL, Sport, ST, ST-Line, Titanium | 4 Cyl 2.0 L GAS, 6 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
View related parts
Ford Edge Position Sensor, Front Passenger Side Part Number: 7T4Z-14B422-A
$238.49 MSRP: $371.48
You Save: $132.99 (36%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Electronic Module; Seat Track Position Sensor, Front Right
- Manufacturer Note: Module
- Position: Front Passenger Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2009 Ford Edge | Limited, SE, SEL, SEL Plus, Sport | 6 Cyl 3.5 L GAS
View related parts
Ford Edge Position Sensor, Passenger Side Part Number: 8A5Z-14B422-C
$515.89 MSRP: $757.55
You Save: $241.66 (32%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor Assembly - Body Weight; Seat Track Position Sensor, Front Right; Air Bag Seat Sensor Mat, Right; Air Bag Sensor; Occupant Sensor; Sensor Assembly - Body Weight - Airbag
- Manufacturer Note: Sensor
- Position: Passenger Side
- Replaces: 7T4Z-14B422-C
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2014 Ford Edge | Limited, SE, SEL, SEL Plus, Sport | 4 Cyl 2.0 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.7 L GAS
View related parts
Ford Edge Module, Passenger Side Part Number: DT4Z-14B422-B
$169.41 MSRP: $261.43
You Save: $92.02 (36%)
ADD TO CART
Product Specifications
- Other Name: Monitor - Airbag Diagnostic Module
- Manufacturer Note: Module
- Position: Passenger Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2013-2014 Ford Edge | Limited, SE, SEL, Sport | 4 Cyl 2.0 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.7 L GAS
View related parts
Ford Edge Air Bag Sensor, Passenger Side Part Number: AT4Z-14B422-B
$161.36 MSRP: $324.40
You Save: $163.04 (51%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Monitor - Airbag Diagnostic Module; Air Bag Seat Sensor Mat, Right; Sensor
- Manufacturer Note: Module
- Position: Passenger Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2010 Ford Edge | Limited, SE, SEL, Sport | 6 Cyl 3.5 L GAS
View related parts
Ford Edge Air Bag Sensor, Front Passenger Side Part Number: AT4Z-14B422-A
$179.36 MSRP: $360.58
You Save: $181.22 (51%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Monitor - Airbag Diagnostic Module; Air Bag Seat Sensor Mat, Front Right
- Manufacturer Note: Module
- Position: Front Passenger Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2010 Ford Edge | Limited, SE, SEL, Sport | 6 Cyl 3.5 L GAS
View related parts
Ford Edge Position Sensor, Front Driver Side Part Number: JJ5Z-14B416-A
$28.95 MSRP: $41.07
You Save: $12.12 (30%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Seat Position; Front Left Seat Track Position Sensor; Seat Recline Position Sensor.
- Position: Front Driver Side
- Replaces: JJ5Z-14B416-C, DG9Z-14B416-E, DG9Z-14B416-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2015-2024 Ford Edge | SE, SEL, Sport, ST, ST-Line, Titanium | 4 Cyl 2.0 L GAS, 6 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS
View related parts
Ford Edge Module, Passenger Side Part Number: DT4Z-14B422-A
$182.82 MSRP: $282.13
You Save: $99.31 (36%)
ADD TO CART
Product Specifications
- Other Name: Monitor - Airbag Diagnostic Module
- Manufacturer Note: Module
- Position: Passenger Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2013-2014 Ford Edge | Limited, SE, SEL, Sport | 4 Cyl 2.0 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.7 L GAS
View related parts
Ford Edge Module, Passenger Side Part Number: CT4Z-14B422-B
Product Specifications
- Other Name: Monitor - Airbag Diagnostic Module
- Manufacturer Note: Module
- Position: Passenger Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2012 Ford Edge | Limited, SE, SEL, Sport | 4 Cyl 2.0 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.7 L GAS
View related parts
Ford Edge Module, Passenger Side Part Number: BT4Z-14B422-B
Product Specifications
- Other Name: Monitor - Airbag Diagnostic Module
- Manufacturer Note: Module
- Position: Passenger Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2011 Ford Edge | Limited, SE, SEL, Sport | 6 Cyl 3.5 L GAS, 6 Cyl 3.7 L GAS

Ford Edge Occupant Detection Sensor

OEM Occupant Detection Sensor boasts unmatched quality. Each part goes through full quality checks. They adhere to Ford's official factory standards. These steps remove flaws and inconsistencies. So you can get Occupant Detection Sensor with long life and a perfect fit. Come to our website and find genuine Ford Edge parts. We keep a wide inventory of OEM Edge parts at the highly affordable prices. It's easy to search, compare, and pick what you need. You'll love the clear info and simple checkout. We offer top-rated customer service, and we reply fast. We also ship promptly to ensure your order arrives on time.

Ford Edge Occupant Detection Sensor Parts and Q&A

Position Sensor, Front
7T4Z-14B416-B
Q: How to service the Occupant Detection Sensor on the power seat track on Ford Edge?
A:
The servicing process for the occupant detection sensor on the power seat track begins by handling the front passenger seat assembly and track with care to prevent damage occurrence. It is normal for the air bag warning indicator to show illumination when both the restraints control module (RCM) fuse is extracted and the ignition switch is ON. Operation of the SRS with all faults repaired should precede vehicle handover to the customer. Remove the power seat track by first notating the positions of its two rails. To perform this task start by detaching the nut and safety belt buckle from the inboard ODS weight sensor bolt followed by removing the front retainer and outboard seat track riser cover shield. The two retainers together with the Occupant Detection Sensor weight sensor bolt protection bracket must be extracted. To fix the defective ODS weight sensor bolt on one side you must remove its nut from the seat track front cross brace while discarding both ODS weight sensor bolt nuts from that side. Cut the front seat track motor cable away from the damaged seat track rail before taking off its side plate with ODS weight sensor bolts installed. The plate should be clamped to a bench or table without excessive tightening because damage will occur. The retaining clip on the faulty ODS weight sensor bolt must be discarded before opening the clamp to extract the bolt with its spring washer. Start by setting the ODS weight sensor bolt together with spring washer inside the side plate before using the clamp to compress it. Remove the clamp from the side plate when the retaining clip sits completely in the groove under the ODS weight sensor O-ring seal. Reinstall the front seat track motor cable and ODS weight sensor bolts according to their necessary positions on the seat track rail and secure them using two new ODS weight sensor bolt nuts tightened to 33 Nm (24 lb-ft). Install the front cross brace seat track nut while providing a torque of 20 Nm (15 lb-ft). Install the ODS weight sensor bolt protection bracket together with the two retainers followed by the front retainer and outboard seat track riser cover shield. The last step involves installing the safety belt buckle and nut while tightening them to 40 Nm (30 lb-ft). The power seat track and passenger seat should be reinstalled afterward. Repower the SRS but delay the proof out procedure and execute the correct procedure based on original or new ODS system component installation which requires a Zero Seat Weight Test or System Reset procedure.