A transmission automatic transmission shift lever requires servicing by first placing the automobile into neutral position on a hoist. You should start by placing the floor shift automatic transmission shift lever into (D) mode before using a pick to elevate the upper shift lever trim ring so you can proceed to detach the top finish panel. Disconnect the
Shift Cable by detaching the end of the cable from the gearshift lever as well as removing it from the supporting bracket. Begin by taking out the shifter through a process of disconnecting electric wires and unscrewing four bolts. Start by installing the shifter assembly while tightening its 4 bolts to 25 Nm (18 ft. lbs.) before reconnecting the electrical connector. To complete the installation you should start with the upper center console assembly followed by the upper shift lever trim ring while paying attention to properly position the thick tab on the driver side front of the shifter before pressing it into position. Finish the process by readjusting the shift cable.