Other Name: Handle - Door Inside; Interior Door Handle, Front Right Inner; Exterior Door Handle; Handle; Interior Door Handle
Manufacturer Note: BLACK
Position: Front Inner Passenger Side
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2001-2007 Ford Escape | Hybrid, Limited, XLS, XLT, XLT No Boundaries, XLT Sport | 4 Cyl 2.0 L GAS, 4 Cyl 2.3 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.3 L GAS, 6 Cyl 3.0 L GAS
Other Name: Handle - Door Inside; Interior Door Handle, Rear Right Inner; Interior Door Handle
Position: Rear Inner Passenger Side
Replaces: 2L8Z-7826602-BAC, YL8Z-7826602-AAA
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2001-2007 Ford Escape | Hybrid, Limited, XLS, XLT, XLT No Boundaries, XLT Sport | 4 Cyl 2.0 L GAS, 4 Cyl 2.3 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.3 L GAS, 6 Cyl 3.0 L GAS
Other Name: Handle Assembly - Door - Inner; Interior Door Handle
Position: Upper Driver Side
Replaced by: LJ6Z-5822601-D
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2020-2021 Ford Escape | S | 3 Cyl 1.5 L GAS
| Page 1 of 4 |Next >
1-20 of 76 Results
Ford Escape Door Handle
Welcome to our website where you can discover high-quality, genuine Ford Escape Door Handle. We offer an extensive inventory of OEM Ford Escape Door Handle at affordable prices. We are committed to providing top-rated customer service along with prompt delivery.
Q: How to service and repair the rear interior door handle on Ford Escape?
A: In order to fix the rear interior door handle, you need to begin by taking out the rear door trim panel and putting the watershield aside. Next, dismount the interior door handle clip and cable, cable conduit and door latch cable. Lastly, undo the procedure to install it all again.
Q: How to Service and Repair the Rear Door Handle on Ford Escape?
A: In order to repair the exterior rear door handle, take off the trim panel and watershield, undo the door latch electrical connector and lay aside the rear door glass top run. Disassemble the actuating rod, unscrew the handle screws and remove the handle. Installation is by reversing of steps.