Other Name: Frame Assembly; Suspension Subframe Crossmember, Front; Crossmember
Position: Front
Replaces: LB5Z-5C145-B
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2020-2023 Ford Explorer | Base, King Ranch, Limited Hybrid, Platinum, Platinum Hybrid, ST | 6 Cyl 3.0 L GAS, 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L FULL HYBRID EV-GAS (FHEV)
Other Name: Member Assembly - Floor Cross; Floor Pan Crossmember; Floor Side Rail; Rear Crossmember; Floor Crossmember; Crossmember
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2011-2019 Ford Explorer | Base, Limited, Platinum, Sport, XLT | 4 Cyl 2.0 L GAS, 4 Cyl 2.3 L GAS, 6 Cyl 3.5 L GAS
| Page 1 of 2 |Next >
1-20 of 21 Results
Ford Explorer Front Cross-Member
OEM Front Cross-Member boasts unmatched quality. Each part goes through full quality checks. They adhere to Ford's official factory standards. These steps remove flaws and inconsistencies. So you can get Front Cross-Member with long life and a perfect fit. Come to our website and find genuine Ford Explorer parts. We keep a wide inventory of OEM Explorer parts at the highly affordable prices. It's easy to search, compare, and pick what you need. You'll love the clear info and simple checkout. We offer top-rated customer service, and we reply fast. We also ship promptly to ensure your order arrives on time.
Q: How to service and repair the Rear Crossmember and Front Cross-Member for transmission support on Ford Explorer?
A:
Start the transmission support crossmember service by placing the vehicle into neutral on a hoist system. The installation requires you to first remove the four transfer case skid plate bolts then take away the transfer case skid plate which should be tightened to 15 Nm (133 lb-in) before reinstalling it. Begin by uninstalling the right heat shield bolt until it reaches 18 Nm (159 lb-in) torque after which install the left heat shield bolt following the same specifications. Insert a suitable jack under the transmission for support before untightening the two transmission mount nuts that need to be fastened to 90 Nm (66 lb-ft) during reinstallation. Remove the six lower bolts from the transmission crossmember before installation while tightening them to 80 Nm (59 lb-ft). During the reinstallation step secure the transmission crossmember with 143 Nm (105 lb-ft) torque on both upper nuts and bolts. Execute the reverse order of removal to install the transmission crossmember.